eco-friendly yellowish, transparent PU Adhesive , 20kg/bucket
It is a single-component polyurethane adhesive that is superior in
performance, convenient in use.
This adhesive is tested to be eco-friendly, light smell, high
viscosity, good cut and peel strength, heat resistant, anti-aging,
It can resist water, oil dirt and eroding after the adhesive film
foamed and solidified.
Appearance: yellowish, transparent
Packaging: 200kg/barrel, or 20kg/bucket
MDI environment-friendly adhesive: It is mainly made from polyether
polyol and Diphenyl-methane-diisocyanate. The raw materials and
accessories are all of high grade, Finished products contain no
TDI, Toluene xylene, short chain chlorcosane, DOP, MOCA etc. reach
colorless and odourless grade. Viscosity and consistency is just
right for construction. Solidifying time can be adjusted according
to actual environment temperature. To avoid the yellowing
phenomenon of adhesive itself, anti-ultraviolet agent and ani-aging
agent are especially added to delay color change. It passes oral
test and all other relevant standards.
This product is applicable to the pavement of the ventilation
plastic racetrack and the production of the safety ground mats ,the
pavement of stadium and playground.
And its weak adhesiveness before the cross-linking hardening will
not stick to the tools and instruments and thus will facilitate the
construction, reduce the usage of organic solvent and save costs.
The superiority of this product lies in its resistance from
hardening, high elasticity and rebound rate , making more
comfortable to footing on it as well as maintaining sound motility.
1. Normal temperature adhesive: This product can be glued to most
solid items, for example: its ratio with REM granules at bottom
layers of athletic tracks is 1:7; with EPDM granule for playground
is 1:6; with EPDM for court is 1:5.5 ,Under temperature 20C, 20- 30
% humidity condition, solidifying time is 8 hours and time for
strength complete reaction is about 24 hours (Adhesive proportion
could be increased according to physical requirements.).
2. High temperature adhesive; 1ts main raw materials and techniques
are roughly the same as normal temperature adhesive. The
solidifying time on heating equipment of high temperature is about
8 minutes (depending on different time and temperature set). Its
mainly used to make rubber tiles, rubber rolls and other high
temperature mold-pressed binding materials.