OC-F08 series online CO2 gas detector used the original imported
sensor and the ultra low power 32 bit microprocessor, so with the
advantages of high precision, good repeatability, stable signal,
respond quickly, etc. Possible connected with many controller
system, such as PLC, DCS, computer and other, with the function of
remote monitor and alarm, data logger and analysis.
Common applications is gas safety inspection and alarm for
industrial scene, such as petroleum refinery, chemical plants, LPG
stations, boiler rooms, gas stations, paint spray booths,
metallurgy, mining, fire, environmental protection, etc., where
need to inspect the Carbon Dioxide CO2 gas concentration.
Features of the Fixed CO2 gas detector:
4-20mA standard analog signal and RS485 digital signal output,
200~1000HZsignal output, relay output, data restore, data
LED screen displaying the gas concentration, gas type, unit,
instrument status etc.
Independent air chamber, the sensor is not required to replace the
sensor calibration, automatic identification of key parameters of
Protection function to prevent high gas concentration attack.
Display the gas concentration in ppm, %vol and mg/m3 is selectable.
Infrared remote controller operation;
With the 16bit ADC acquisition chip, designed with four-layer
circuit board, so with high anti-interference ability.
With the Ex-proof certificate, the Ex-proof grade is Exd II CT6.
Optional wireless transmitting and receiving module.
Technical Parameter of the Fixed CO2 gas detector:
|Applicable Gas||Carbon Dioxide (CO2)|
0~20%vol, 0~100%vol or customized|
|Resolution||0.01ppm, 0.1ppm, 1ppm, 0.01%vol|
|Sampling||Diffusion or pump-suction, circulation selectable|
|Sensor Type||Infrared sensor|
|Sensor Life||2~3 years|
|Response Time (T90)||≤20s|
|Alarming mode||Audible-visual alarm(Optional)|
Temperature: -30℃~60℃ (Customized for special demands)
Humidity: ≤95%RH (non-condensing); if >90%RH, can add the filter
|Working Voltage||24V DC(16~30VDC)|
(Standard)Three-wire system 4~20mA standard signals output,
available for PLC, DCS, etc;
(Optional) Four-wire system RS485 digital signal output;
(Optional) Frequency signal 200~1000Hz output;
Two-level relay output:220VAC 0.5A, 5VDC 0.5A
|Installation Model||Wall mounted, Pipe type(Thread:M40*1.5 )|
|Material of Body||Cast aluminum|
|Explosion-proof Index||Ex d IIC T6|
|Electrical Interface||3/4″NPT(Female Screw),1/2″NPT(Female Screw)|
|Dimension||210 mm×140 mm×92 mm(L×W×H)|