DONGWE 40G SR QSFP, Fiber Optic Module/Transceiver, Cisco
compatible
Features
4 channels full-duplex transceiver modules
Transmission data rate up to 10.5Gbps per channel
4 channels 850nm VCSEL array
4 channels PIN photo detector array
Low power consumption <1.5W
Hot Pluggable QSFP form factor
Maximum link length of 100m on OM3 Multimode Fiber (MMF)and 150m
on OM4 MMF
Single MPO connector receptacle
Built-in digital diagnostic functions
Operating case temperature 0°C to +70°C
3.3V power supply voltage
RoHS 6 compliant(lead free)
Applications
40GBASE-SR4 40G Ethernet
Datacom/Telecom switch & router connections
Data Aggregation and Backplane Applications
Proprietary Protocol and Density Applications
Infiniband transmission at 4ch SDR, DDR and QDR
Description
The DONGWE Technologies DW-D4085-01CQ is a Four-Channel, Pluggable,
Parallel, Fiber-Optic QSFP+
Transceiver for 40 Gigabit Ethernet Applications. This transceiver
is a high performance module for short-range
multi-lane data communication and interconnect applications. It
integrates four data lanes in each direction with 40
Gbps bandwidth. Each lane can operate at 10.3125 Gbps up to 100 m
using OM3 fiber or 150 m using OM4 fiber.
These modules are designed to operate over multimode fiber systems
using a nominal wavelength of 850nm. The
electrical interface uses a 38 contact edge type connector. The
optical interface uses an 12 fiber MTP (MPO)
connector. This module incorporates DONGWE Technologies proven
circuit and VCSEL technology to provide
reliable long life, high performance, and consistent service.
QSFP+ SR4 is one kind of parallel transceiver. VCSEL and PIN array
package is key technique, through I2C
system can contact with module.
DIAGNOSTIC MONITORING INTERFACE
Digital diagnostics monitoring function is available on all DONGWE
QSFP+ SR4. A 2-wire serial interface
provides user to contact with module.
The structure of the memory is shown in Figure 5. The memory space
is arranged into a lower, single
page, address space of 128 bytes and multiple upper address space
pages. This structure permits timely
access to addresses in the lower page, such as Interrupt Flags and
Monitors. Less time critical time entries,
such as serial ID information and threshold settings, are available
with the Page Select function.
The interface address used is A0xh and is mainly used for time
critical data like interrupt handling in order
to enable a one-time-read for all data related to an interrupt
situation. After an interrupt, IntL, has been
asserted, the host can read out the flag field to determine the
affected channel and type of flag.
Ordering information
Part Number Product Description
DW-D4085-01CQ QSFP+ SR4, 100m on OM3 Multimode Fiber (MMF)and 150m
on OM4 MMF
References
1. SFF-8436 QSFP+
2. Ethernet 40GBASE-SR4
Important Notice
Performance figures, data and any illustrative material provided in
this data sheet are typical and must be
specifically confirmed in writing by DONGWE before they become
applicable to any particular order or
contract. In accordance with the DONGWE policy of continuous
improvement specifications may change
without notice.
The publication of information in this data sheet does not imply
freedom from patent or other protective rights
of DONGWE or others. Further details are available from any DONGWE
sales representative.
Contact:
Email: sales055@dongwe.cn
Skype: dongwe055
Whatsapp: +86 189 2640 2115
Web: http://www.dongwe.cn
http://www.fiber-optics-e.com
