Fulund factory CE Approved transfer heat fabric cloths textiles
machines automatic four station heat press transfer mug
Heat transfer machine maintenance:
1. Pressure: If the pressure is not enough or too high, adjust the
pressure screw (located at the bottom of the aluminum plate),
clockwise to increase the pressure, and counterclockwise to
decrease the pressure.
2. Time: When the hot stamping time arrives and the buzzer does not
ring or keeps ringing, it is necessary to check whether the contact
point of the micro switch in the tail box is appropriate. If it is
not suitable, it must be adjusted to an appropriate position.
3. Temperature: Preheat for about 15 minutes. When the temperature
reaches the set temperature, the heating indicator will be off, and
hot stamping can be started; if the heating plate does not heat up
for a few minutes, please check the circuit.
1. Single Double or Four stations heating(optional)
2. independent temperature controller
3. Semi Automatic move and automatic press
4. Temperature tolerance less than ±3ºC
5. Serveral sizes of work table options:
38x38cm
40x50cm
40x60cm
6. Laser line positioning(optional)
7. Warranty: one year
8. Certificate:CE
Pneumatic automatic heat press machine
This Pneumatic automatic heat press machine was semi automatic
machien that heat press fabric, cloth, poster, mouse pad,sheet,etc.
It is pulled by hand and press automatically. This press machine
provide really steady perfermance and long life expectancy.
