Long Strip cob Size 60*40 5w 12V CE ROHS Sanan Chip Battery
Rechargeable Used in Camping / Car light
Characteristics
Setting Information |
Power | 5w |
Voltage | 12-14 v |
Size | XC-120*40/112*26 led cob chip |
Lumens | 120-130lm/W |
Temperature | 3000- 6500K |
Chip Brand | Sanan |
luminous surface | 112*26 |
Absolute Maximum Ratings
- LEDs Type: XC- Long strip cob chip for Camping light / Car light
- Size: XC-60*40MM
- Wattage: 5W
- Voltage: 12-14V
- CRI: >80
- Luminous efficacy: 120-130LM/W
- Color Temperature: 2700-6500k
- Operation temperature: -30℃-+75℃
- Storage temperature: -30℃-+ 75℃
- Case Temperature: 85℃
- Junction Temperature: 125℃
- Soldering Temperature: 350℃± 10℃ For 5 Seconds
- ESD Sensitivity: 2000V HBM
This lamp bead is constant voltage, mainly used for the lighting of
flashlights , camping light and car lights. Conveniently powered for hours with 3 AAA batteries or a single
rechargeable battery
Product Introduction
1-1 Features
◆ Mechanical Dimensions : 60 x 40 x1.7(mm)
◆ Package Structure :Aluminium Base Chip on Board
◆ CRI(Ra): Min.70/ Min.80
◆ Nominal CCT : 2700K-6500k
◆ Chromaticity Range : 3-step MacAdam Ellipse
◆ RoHS LM-80 compliant
◆ Better die arrangement for optics
1-2 Applications
Car Light / Camping Light
Application
User Manuel
1. Storage
To avoid moisture, we recommend storage conditions for the unopened
LED +5 ~ +30℃ rela-tive humidity <60%. LED should be used within
168 Hrs. of opening the package. Please make sure to dehumidify and
vacuum pack the remaining/ unused LED. Dehumidifying condition:
+120℃±5℃ of 4Hrs. Effective age for the sealed led is one year.
2. The soldering precautions
Soldering conditions: Reflow soldering is not recommended for this
LED. If hand soldering, set sol-dering iron temperature at 350℃ and
soldering time not More than 5 seconds, after the first soldering,
make sure the substrate surface temperature returns to ambient
temperature before a second soldering. Please. make sure when
soldering, there is no external force on the soldering surface and
silicon batardeau (such as pressure, friction or sharp metal nails,
etc.), to avoid gold wire deformation or dam-age and other
abnormalities. If beyond recommended conditions, we cannot
guarantee the LED stability, please do the risk assessment first.
During assembly, please ensure that a good quality thermal paste is
applied and distributed evenly over the surface. While using
thermal pad (Heat Sink), make sure LED is firmly tightened and
there is no gap between surfaces. In such heat-media products,
through a pressure test of at least 500 volts.
3. Anti-static measures
Please take adequate measures to prevent electrostatic generation,
such as wearing electrostatic ring or anti-static fingerstall etc;
any relative products like plant equipment, machinery, carrier and
transpor-tation units shall be connected to discharging unit/
ground. The ESD sensitivity of this product is > 1000V(HBM),
after assembly the final lamp, please make sure to discharge Static
Electricity by proper ESD equipment.
4. Temperature control
Recommended temperature conditions for enhanced product life: Be
sure to TS point (negative pads) controlled below 85℃, COB
recommendation colloid surface temperature control ≤150℃.
Trade Show
