Main ingredients……………………………Chloroprene rubber,Thicken resin, deionized Water
Appearance…………………………………White or pink, no smell
Operation……………………………………Manual + Automatic Spray
Component…………………………………2 component
Solid content ………………………………43±3%
Adhesive type………………………………CR rubber based Adhesive
Viscosity cps (25℃)………………………18±5 CPS/25℃
Gravity………………………………………1.1~1.2
Heat resistance………………………………≥80℃
Shelf life ……………………………………6-12 month
Notes for operating:
1. Use a special double nozzle (hole) spray gun for two-component
water-based spray glue, and remove impurities on the surface of the
material;
2. According to specific needs, spray glue evenly on the surface of
the material, spray on both sides, and the spray effect should be
linear granular. Material A and material B are sprayed from double
nozzles.
The muzzle sprays and merges, and it sprays on the surface of the
material to cause a catalytic reaction, which can achieve effective
bonding in a short time.
3. The spray gun moves steadily, sprays evenly, does not lack glue,
does not accumulate glue, and the glue layer should not be too
thick or too thin;
4. After spraying, you can spray and stick immediately. The bonding
must be completed within 10 minutes after spraying, and reasonable
pressure must be applied after bonding (the glue layer is generally
about 24 hours
After curing, the tensile force reaches the maximum within 48
hours).
5. During construction, the pressure of 1088 component A latex
should be adjusted to about 0.15-0.35MPa, and the pressure of 1088
component B catalyst should be adjusted to
About 0.03-0.05MPa, the output ratio of material A and material B
can be balanced by adjusting the conveying air pressure. You can
use the waste material for testing first.
The output ratio of material A to material B is generally (3-5):1
until the viscosity effect required by the operation is achieved.
6. In order to reduce the drying time, adjust the appropriate
amount of glue when spraying. Under the premise of satisfying the
viscosity, the smaller the amount of glue, the better.
Note: 1. After construction, if the glue needs to be removed, it
can be removed with water before the glue is not cured.
