Replace FG Wilson Engine Interface Module EIM PLUS BASIC 630-465
Product Description:
The FG Wilson Engine Interface Module is a sealed engine mounted
module that provideds switching relays for the starter motor
solenoid, glow plug and fuel solenoid.
Each of these circuits is protected with individual automative
fuses mounted in the module. Individual LED’s illuminate when each
circuit is energized in addition these LED’s greatly aid when fualt
finding.
This module is mounted on the engine with anti-vibration mounts and
is easily connected to the engine via loom plugs. Use of the FG
WILSON EIM 630-089 means that heavy currents such as fuel solenoid
power are isolated from the control panel thus enabling individual
protection of each of the circuits.
How to Install FG Wilson EIM?
Ensure the MPU(Magnetic Pickup) is installed correctly.
Unscrew and pull out the magnetic pickup that is located near the
flywheel of the engine
Inspect the magnetic tip and ensure that is it clean and free of
debris.
Screw the MPU in until the tip makes contact with the top of the
flywheel teeth.
Back out the magnetic pickup 1/2 to 3/4 of a turn.
Turn the ten-turn potentiometer between five to seven turns
clockwise or just until you feel a small click-signifying the full
span of the pot.
Start the generator set,you will notice the overspeed calibration
LED illuminated.
Slowly turn the potentiometer counter-clockwise until the LED just
turns off.
As soon as the LED turns off,start to slowly turn back the
potentiometer clockwise just until the led starts to flicker.
