1.Working principle: When bottles are sent to the machine by conveyor continuously, they
firstly are deliveried to the receiving wheel by air-slide conveyor
and then to washing part. The bottle clamps hold the bottles and trun over 180° to wash, then
return back to their original position after enough washing and
drying. The bottles are sent to the middle thumb wheel 1 and to the
filling part to be filled, then moved by middle thumb wheel 2 and
reach to capping part to be capped, at the same time, cap trimmer
sends caps to the top of the bottles and capper screws caps. Bottles are sent to the conveyor chain by the out stirring wheel to
next working position.
Working Process I. Into the bottle device 1).The air conveyor is connected with into the bottle star-wheel. 2). It has bottle locked protection device. II. Washing Part 1). The rotary disk is fully made of SUS304 stainless steel. 2). Using company original tilting bottle clip, bottle clamp stuck
bottleneck, avoid the traditional bottle on rubber clip to block
the bottle thread parts may be caused by the pollution. Bottle clip
is made of SUS304 stainless steel, health and durable. 3). Washing part moves by a frame in the transmission system
through the gear transmission. III. Star-wheel 1). It adopts the good stainless steel star-wheel. 2). It has bottle locked protection device. IV. Filling machine 1). The washing bottle, filling, sealing are connecting with the
thumbwheel card bottleneck transportation methods. 2). The rotating disk is all made of SUS304 stainless. 3). Filling method is pressure filling. 4). Filling valve manufactured by SUS304. 5). The filling valve structure design is reasonable, the filling
quantity is accurate. 6). Filling machine motivation by the rack drive system through
gear transmission. V. Capping machine The capping machine is the highest precision in 3-in-1 unit
machine, on the reliability of equipment operation, has enormous
influence on the defective rate of the product. VI. Out bottle star-wheel 1). It uses nylon thumbwheel conveyor chain. 2). It has bottle locked protection device. VII. Electric control system The electric control cabinet is made of 304 stainless steel rack.
It is equipped with maintenance lights, PLC automatically control
the filling process from bottle come in to come out of filling
machine. | 
