Xtruck HDD Y009 Diagnostic Tools
Xtruck HDD Y009 can be used for two types of diagnostic tools, one
of which is for construction machinery and the other for heavy
trucks. They look very similar and can be distinguished by color.
The orange one is for excavators equipment and the red one is for
heavy trucks.
Please Pay attention!! This link is for heavy trucks only, if you need the Xtruck Y009 for the excavators equipment version
please contact us.
Xtruck HDD Y009 Applicable Models:
1. Excavators equipment (orange): Multifunctional 6 in 1 (for C-A-T, for V-olvo, for C-umins, for
I-suzu, for H-ino, for Hitachi)
2. Heavy Duty trucks (red): Multifunctional 7 in 1 (for S-Cania SPD3, for V-olvo, for C-A-T
ET3, for C-UMMIS, for I-SUZU, for HINO, for D-etroit)
1. For D-etroit Software
For D-etroit Diesel DiagnosticLink SP0 Professional provides ECU
information, diagnostic fault codes, instrumentation information,
service routines, the ability to run system tests, edit ECU
parameters, and the ability to reprogram engine controllers.
2. For SPD3 Software
The program is used for troubleshooting, adjusting customer
parameters, calibrations, conversions affecting the electrical
system and updating software in control units.
3. For ET3 Software(2021 version)
-With Fast USB communication/Wifi fast communication
-Compatible Vehicle: For Trucks, Excavators, Air Compressors,
Ships, Drilling Rigs
4. For HINO Software(V3.16 Software Version)
5. For ISUZU Software(2022 Version)
For I-DSS function:
Diagnostics (Engine, Transmission, Chasis, Body);
Controller Programming and so on......
6. For V-olvo(2.8.150 Software Version)
-For V-olvo Trucks (Older electrical system, Vehicle electrical
system '98);
-For V-olvo Trucks (VERSION2, VERSION3 - PARAMETER PROGRAMMING);
-For V-olvo Trucks (VERSION4 - FH4/FM4 - PARAMETER PROGRAMMING);
-For V-olvo Buses (Conventional, Multiplexed, Multiplexed v2,
Multiplexed v3);
-For V-olvo Construction Equipment;
-For V-olvo Penta (VERSION2, VERSION3);
-For V-olvo OEM Component Customer (VERSION2, VERSION3);
-For M-ack Trucks (V-MAC I/II/III, ITC, IV, IV+ - PARAMETER
PROGRAMMING);
-For R-enault Trucks (VERSION2, VERSION3, VERSION4 - PARAMETER
PROGRAMMING);
-For U-D Trucks (VERSION2, VERSION3).
7. For C-umins (Software Version: 8.7)
we have optimized the software. It can be installed directly
without a registered machine.
