16 Shades 49% Translucent 98x14mm 1350mpa Vita Zirconia Block

Physical specifications

How to Milling our Vita Zirconia Block

Pre-sintered zirconia material has an inherent shrinkage rate associated with each production. This number of shrinkage rate must be input into the milling preparation software to ensure the accuracy of the eventual restoration.

When milling our zirconia, always follow these general guidelines:

Only use sharp end mills with carbide or diamond coating.

Do not use any restoration that has chips or cracks. Remove the units from the disc using a handpiece with a diamond-coated bur.

Smooth the support areas with a medium-grit rubber polishing wheel.

Remove any residual zirconia dust with an art brush.

If a wet mill is used make sure all the zirconia is completely dry before sintering. Air dry for at least 15 minutes prior to sintering. Damp zirconia will crack if placed in the sintering oven.

UT Multilayer is 1350mpa zirconia with great high translucency, the color is also gradient gives natural result.

No coloring and porcelain is needed. Time saving materials.

Advantages

1. Perfect fit

2. Stable scaling factor

3. Imagination permeability coloring, not only stay on surface

4. Strength and translucent better than any other similar products.

5. Operate fastly, save cutting knives.

6. Professional service and supporting

7. Senior R&D team ensure the continued excellence of our material.