Residential 300kg AC Motor Wifi Mobile Mini App Control Automatic
Slide Gate Opener
MAIN FUNCTION & FEATURES
1. Totally integrated electrical mechanical system (excludes
racks).
2. Control board interface for optional impact-proof infrared
photocells.
3. Can connect flashing light and keypad and electric lock and so
on.
4. Automatic delayed closing.
5. Adjustable resistance sensitivity.
6. Auto gate stop and re-open when an obstacle is encountered.
7. Wireless remote control or wired remote control are optional.
● Easy to install and low maintenance
● Quick selection for gate open/close direction
● Emergency release key in case of power failure
● Stop/Reverse in case of obstruction during gate opening/closing
● Can be equipped with wide range accessories
● Soft start soft stop
● Pedestrian mode
● Protection class: IP44
● Dimensions:24cmX16cmX27.3cm (L*W*H)
● Remote control distance: 30-50m in the open area
● Output gear module:M=4
● Output gear number :Z=16
TECHNICAL SPECIFICATION
| Model | PYM X2208 |
| Power supply | AC 220V±10%, 50Hz; AC 110V±10%, 60Hz. |
| Max loading weight | 300KG |
| Rated power | 130W |
| Gear modulus | M=4 |
| Open/close speed | 12m/min |
| Electric motor | 220VAC/110VAC |
| Output speed | 50r/min±10% |
| Output Torque(N.m) | 12 N.m |
| Limit switch | magnet |
| Working temperature | -20°C～+55°C |
● Power supply: 220V±10%/50Hz, AC 110V±10%, 60Hz.
● Motor: 220V AC/ 110VAC
● Absorbed motor power: 130W
● Gate moving speed: 12m/min
● Max gate weight: 300KGS
● Environmental conditions: From -25°C to +50°C
Standard kit includes:
--1 motor
--2 remote control
--2 manual key
--1 built in control panel
--2 magnets
-- some installation screws
--1 user manual
About packing
1 set/ carton(32cm*24cm*30cm), weight about 9 kg.
40CTNS/ CBM
1200sets /20'Container
Installation procedures
Note:
Before motor installation , sliding gate must installed well with
hardware kit .If any gate hardware kit
require, please contact with us.
Installation procedures
1.The limit default setting is for gate in close position. Before
installation, please make sure gate is closed.
2.Prepare one or more conduits for the electrical cables. Cable
conduits have to pass through the hole in the base plate.
3.Pour concrete and before it starts to harden, check that it is
parallel to the gate leaf and perfectly level.
4.The four anchor bolts must be set into the concrete when it is
poured, make sure the position of anchor bolts was placed according
to the position of mounting holes on the base plate before concrete
become harden.
6.Place the opener onto base plate. Check that it is perfectly
parallel to the gate, and then screw the four bolts and washers
supplied. It's only temporary installation. Further adjustment will
be required when install the rack.
