Four Wheels Mouted BW 160 Triplex Portable Mud Pump For Drilling Rigs

Precautions for using mud pump:

Before starting the mud pump, please check whether the inlet and outlet pipes are blocked, whether butter is added to the front and rear bearings, and whether the packing is full. When the mud pump is working, it should be equipped with a high-pressure clean water pump to transport clean water that is greater than the pressure of the mud pump to the anti leakage packing, and protect the packing. The flushing pump should not be turned off during the operation of the mud pump, otherwise it will cause rapid wear and tear of the sealing part. The reasonable clearance between the impeller and the guard plate has a significant impact on the service life of the mud pump. If the clearance is not reasonable, vibration and noise will occur during the operation of the pump, and the overflow components will be quickly damaged. Therefore, when replacing the impeller, attention should be paid to ensuring that the clearance meets the requirements of the drawing. The adjustment of the clearance can be made through the adjustment screws on the rear bearing body. The allowable suction head of a mud pump is measured when transporting clean water, and the impact of mud on suction capacity should be considered when pumping mud.

Precautions for mud pump operation

1. Pay attention to whether there are any abnormal sounds in each component; Whether the drainage is uniform; Pay attention to the working condition of the pressure gauge if there is any leakage of air, water, or oil. If any problems are found, the cause should be immediately identified and quickly eliminated.
2. The working pressure of the mud pump cannot exceed the rated pressure of the pump; Check the working reliability of the safety valve.
When changing the speed of the mud pump, the belt pulley must be in the idle position first.
When adjusting the pump volume, attention should be paid to the amount of returned flushing fluid; Prevent false punching caused by pipeline blockage and sudden increase in pressure.
5. After transporting cement slurry with a pump, the inside and outside of the pump body, pipelines, etc. must be immediately rinsed with clean water.
6. There should be no impact sound during the operation of the mud pump.
7. Keep the pump clean to prevent flushing fluid from entering the crankcase and moving parts.
8. When the pump is stopped for a long time in freezing and freezing areas, the flushing fluid in the pump body, pipeline and shower head must be drained to prevent the machine from freezing.