11900 BTU/HR of Temporary, spot cooling , delivers 11900 BTU/HR of
efficient, convenient cooling in a variety of smaller environments
where larger units are too much. These air conditioners can also be
used in smaller areas for room cooling. A control panel provides
ease of use and contains a self-diagnostic function and display,
showing operating modes, room and set temperatures, and faults. If
an abnormal operation occurs, a visual display of the fault is
shown. Caster wheels are included for easy portability.
These portable spot air conditioner are preferred because of their
convenience and efficiency -- no water lines need to be introduced
in the desired room. Our portable air conditioners use ambient air
in the surrounding environment so they don’t need any kind of
special intake system to operate. Industrial air coolers created
from the refrigeration process is exhausted off the top of the unit
and can be ducted into the ceiling plenum or directed out the
nearest door or window to exit the room or space.
New innovation
Heating Setup: Portable heat pump combines both cooling and heating capabilities
in a single, self-contained unit, it offers significantly higher
performance, along with the usual high levels of Weixuan quality and reliability.
Dehumidifying Setup: Effective water-damage restoration begins with Weixuan . Dry rooms out quickly to reduce the formation of mold and mildew,
and keep them from spreading further. A Weixuan portable unit ensures substantially faster recovery than with fans
or dehumidifiers, reducing restoration costs.
Best of all, installation is simple. Just roll the unit in, plug it
in, attach the dry-air exhaust duct and turn the unit on. Right
away it starts doing its job. You'll save time and money thanks to
the new dehumidification technology, which is designed to remove
moisture and replace it with dry air. Our machine is the perfect
solution for protecting valuable equipment and property from
moisture damage.
New features
1. Models for outdoor exhaust: Can be connected to outdoor by using
the
2. separately sold exhausted duct.
3. Compact: Compact design without worrying about the placement
area.
4. Super compact: Super compact design, with a placement area of
0.168m2
5. Little Drain: Up-to-date structure integrated with heat
exchanger Significant
6. decrease in drain
7. Snug to wall: Can be placed close to the wall on three sides.
8. Air filter: Easy-to-clean air filter.
9. Durable filter: Large surface area, with no necessary to be
frequently maintained.
10. Built-in auto swing mechanism: An auto swing mechanism is built
in the unit.
Maintenance
There are two fi lters in the unit. The evaporator fi lter is
located at the front of the unit. The condenser fi lter is located
at the side of the unit.
1. loosen up 2 bolts on the front fi lter guard.
2. Slide fi lter up and use a vacuum cleaner to remove the dust
from the fi lter.
3. If the fi lter is heavily covered with dust and dirt, warm water
and mild soap or neutral detergent may be used to wash the fi lter.
Do not use any other chemicals to clean fi lter, as they will
likely damage the fi lter.
4. Dry the fi lter in a shaded area before replacing it. Do not
operate the unit without the fi lter installed and the fi lter
guard in the closed position.
5. Replace the clean fi lter and close the fi lter guard.
6. To clean the condenser fi lter, lift up on the side fi lter from
the middle bar slightly and then angle the fi lter outwards from
the bottom and remove.
7.Use the same cleaning procedure as above (3 – 5).
8. To replace the condenser fi lter, place the top of the fi lter
in the guide and slide the fi lter up until the bottom of the fi
lter clears the frame. Then push the bottom of fi lter into the
guide and let fi lter gently fall inside the guide.
