ADG508FBRNZ-REEL7 Electronic Components IC Chips Surface Mount 15V 1Channels

The ADG508FBRNZ-REEL7 electronic part can be shipped overseas conveniently because it is packaged in 16-SOIC (0.154, 3.90mm Width). In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. Multiplexers like this are mounted in the Surface Mount position. Multiplexers and demultiplexers have the same number of circuits 8:1. Operating temperature extended to -40°C~85°C TA. As a result of its 1 channels, this electronic component provides high-quality output. A 1 circuit is present in this switch device. Try searching for ADG508 variants of the analog switch ic.

The internal resistance of this digital multiplexer is 270Ohm. For functions related to 16 pins, please refer to the datasheets. A voltage higher than 16.5V should not normally be supplied to the switches. Analogue multiplexer with a Dual supply type that is cost-effective. In order for the electronic part to function properly, the lowest voltage should be 10.8V. An operating current of 100nA would be sufficient for this switch device. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. If put voltage greater than 22V on the multiplexer, damage may be caused to the device. This electrical part is compatible with 15V operating voltages. Operating the 8 inputs requires 8 inputs. Temperatures above 85°C should not be used to operate the switches. The analog switch ics has 1 outputs. 16-SOIC package is offered by suppliers.

FEATURES

All switches off with power supply off
Analog output of on channel clamped within power
supplies if an overvoltage occurs
Latch-up proof construction
Low on resistance (270 Ω typical)
Fast switching times
tON: 230 ns maximum
tOFF: 130 ns maximum
Low power dissipation (3.3 mW maximum)
Fault and overvoltage protection (−40 V to +55 V)
Break-before-make construction
TTL and CMOS compatible inputs