Jekit Big Brake Kit White Caliper 8 Pot 362mm Disc Full Floating
Bell
We produces high-tech brake calipers for the original equipment of
high-end models in various categories.
Aluminum fixed brake calipers adopt single structure or two-piece
structure to ensure extreme light weight and best performance. The
number of pistons ranges from 2 to 6, and in some cases up to 8,
depending on the size.
We pays special attention to the design of brake calipers, which
aims to perfectly integrate performance and comfort.
Jekit and the system method used ensure the comfort of the product,
which requires an in-depth understanding of all elements involved
in braking
How to choose brake kit
The improvement of braking performance, good ventilation and heat
dissipation and beautiful appearance are also needed by most car
owners
Under the condition of cost control, the brake with better
performance than the original factory can be installed in the
existing wheel hub size (ig
Four pistons are not necessarily worse than six pistons
The model of the caliper depends on the model and the output power
of the brake master cylinder
After determining the brand, try to choose new brakes. After the
old ones enter the market for a certain period, new products will
replace them
Professional installation of brake discs and brake pads
To prevent problems, the brake disc / brake pad change should only
be carried out by trained personnel. Fundamentally, the following
must be observed:
Brake discs
Only change them for the complete axle, if necessary observe the
direction of run.
Centre properly and mount with the specified torque in the correct
order. Important: Test the axial run-out.
With the replacement of the brake disc, also use new brake pads or
other authorized brake pads (ECE R90 approval).
Wheel hub
Contact surface must be bare (no rust or dirt it may be present).
Do not apply any grease or similar products. A thin layer of
oilspray can be applied for an easier dismantling.
Contact surface and centring may not be damaged.
Contact surface must be level (hub imbalances cause axial
run-out!).
Brake pads
Use our brake pads or other authorized pads.
Select the appropriate pads according to the vehicle type / year of
make.
Run-in the brakes in a professional manner, avoiding violent
braking.
Brake calliper
Check the protective caps for damage and replace if necessary.
Check the pistons and guide elements for damages and proper
function, and replace if necessary.
Ensure the smooth running of the new pads in the calliper slot.
Wheel suspension
Wishbone suspension arms and stabilizer rubber bushings may not be
worn out, if necessary replace.
Check the shock absorbers and replace if necessary.
Check the front axle settings according to manufacturer's
specifications and adjust if necessary.
Wheel bearings
Check the clearance and adjust or secure accordingly if necessary.
Steering parts
Check the steering clearance and adjust if necessary.
Check the steering track rods and steering dampers for damages and
proper function, and replace if necessary.
Wheels / tires
Check for unbalance and balance if necessary.
Testing of the vertical and lateral run-out, axial and radial run
of the rim, and maintaining of the specifications.
Full set brake system
| 2pcs brake caliper |
| 2pcs brake disc |
| 2pcs brake hose |
| 2pcs aluminum center bell |
| 2pcs aluminum bracket |
| 2pcs brake hose |
| 4 pcs brake pads |
