KLD800 series 80G Radar Level Gauge Strong corrosion resistance
The high-frequency 80g radar level gauge has the advantages of low
maintenance, high performance, high precision, high reliability,
and long service life. Compared with contact instruments such as
capacitors and weights, it has incomparable advantages. The
transmission of microwave signals is not affected by the
atmosphere, so it can meet the requirements of harsh environments
such as volatile gas, high temperature, high pressure, steam,
vacuum and high dust in the process. This product is suitable for
harsh environments such as high temperature, high pressure, vacuum,
steam, high dust and volatile gas. Continuous measurement of
different material levels is possible.
The main technical indicators of the instrument have reached or
surpassed similar products at home and abroad, and it is easy to
install and debug. It can be used alone or in a network. It can be
widely used in metallurgy, building materials, energy,
petrochemical, water conservancy, food and other industries.
Feature
⚫ Millimeter wave radar, the measurement accuracy can reach up to
±2mm, and the
minimum measurement blind zone is 0.05m.
⚫ The smaller antenna size satisfies the measurement of more
working conditions.
⚫ A variety of lens antennas, smaller launch angles, more
concentrated energy, stronger
echo signals, and higher reliability than other radar products
under the same industrial
and mining conditions.
⚫ It has stronger penetration and can be used normally in the case
of adhesion and
condensation.
⚫ The dynamic signal range is larger, and the measurement of low
dielectric constant
media is more stable.
⚫ Multiple measurement modes, radar response in fast measurement
mode
Technical Specification and Model Selections
| Model | KLD804 |
| Medium | strong corrosive liquid, steam, foam |
| Measuring range | 0.1m~10/20/30/60/100m |
| Process connection | flange ≥ DN50 |
| Process temperature | -40～130℃ |
| Process pressure | -0.1～1.0MPa |
| Antenna size | 76mm lens antenna |
| Antenna material | PTFE |
| Accuracy | ±1mm |
| Protection class | P67 |
| Center frequency | 80GHz |
| Launch angle | 2° |
| Power supply | Two-wire /DC24V / four-wire /DC12~24V / four-wire /AC220V |
| Casing | aluminum/plastic/stainless steel |
| Signal output | two-wire /4...20mA/HART protocol four-wire / 4...20mA/ RS485 Modbus |
FM radar level gauge installed normally three detection methods
First of all, carry out on-site inspection to observe whether the
actual working conditions on site are suitable for the model
product of the radar level gauge, and confirm whether the
installation position is correct and whether the installation
environment affects the use of the instrument, etc., so as to avoid
the final failure and affect the use. In addition to the on-site
inspection of the radar level gauge, other instruments must also
carry out this work, which is relatively basic.
Next, perform a power-on check. Because after the power is turned
on, it can be observed whether the radar level gauge enters step by
step according to the normal startup procedure and displays
normally. And there are many accidents that occur because of
power-on, or not power-on at all, and the instrument will not work
normally. If the site permits, you can also observe whether the
level gauge changes linearly and other parameters through the
material in and out.
Next, a connection check is performed. This overlaps with the
on-site inspection, that is, the linearity of the level gauge can
be observed by connecting to the corresponding software. Generally
speaking, instruments with buttons can also achieve this function.
Users can also check the connection through professional
instruments to judge whether the radar level gauge is operating
normally.
In addition to the above methods, there are many other ways to
detect the situation of the radar level gauge after installation,
so that the instrument can be used normally without affecting the
work progress.
Connection
KLD800 series product show
