Auto Laminator 1450mm High Accuracy Flute Lamination Machine
Laminating Corrugated Carton
Working principle
The paper is sent out by the paper feeder and sent to the actuator
of the gauge mechanism to detect the paper
Send out;The paper and the paper are sent to both sides of the
paper respectively after the paper is coated with glue by the
rubber wheel
Synchronization detector, after detection by the controller
calculation of the paper and base paper error, and from the paper
two
The side servo compensator compensates the surface paper to a
predetermined position for bonding, and then passes through a
pressurized conveyor
Press the paper and transfer to the paper receiver to collect the
finished product
Applied materials
Tissue paper -180 ~ 800g/m of thin paper, cardboard.
Base paper -0.5 ~ 10m/m of cardboard, single-sided paper,
multi-layer paper, pearl board, honeycomb board, etc.
Glue - water - based glue, PH between 6 and 8, can be applied to
paper glue.
Specifics:
| Model | ZGFM-1900 |
| Max Sheet | 1900×1900mm |
| Min Sheet | 500×500mm |
| Top Paper Thickness | 150-800g/㎡ |
| Max Speed | 150m/min |
| Fitting Precision | ±1.5mm |
| Machine Power | 20KW |
| Bottom Paper Thickness | ≤10mm(A-F corrugated board) |
BRANCH INTRODUCTION:
1. BOTTOM PAPER FEEDING
Use imported Servo motor electric controlling system, with Japan
NITTA suction belt to make suction power inverter, and belt cleaned
by water roller; Patented technology to ensure corrugate and
cardboard goes out smoothly and simple operation.
2. TOP SHEET FEEDING MECHANISM
Equipped with high speed auto dedicated feeder, both paper lifting
and feeding nozzle can freely adjust angle to the paper, to ensure
that whether thick or thin paper can be delivered rapidly and
smoothly.
3. ELECTRICAL SYSTEM
Designed in the accordance with European CE requirement, ensure
machine stability, high efficiency and low failure. Using
man-machine interface and PLC combination, display all the
information, such as warning, error detect, failures, and operating
speed, etc on the screen at a glance.
4. PRE-STACK PART
Pre-stack pile of paper under the condition of non-stop, improve
efficiency.
The special design of the pre stack paper frame, save time and
effort.
5. TRANSMISSION
With imported double teeth belt drive and Switzerland ROSTA tension
device ensure the drive accurate, stable and low noisy.
6. POSITIONING SYSTEM & GLUE ROLLER
The use of multiple sets of photoelectric sensor at bottom sheets
relative position, control top sheets on both sides of the servo
motor to do independent compensation action, so that accurate
positioning of top paper and the bottom paper.
Stainless steel roller, never rust, after narrowly grinding,
guaranteed the minimum amount glue coated evenly.
Down roller be cleaned by water roller.
7. TOUCH SCREEN OPERATION SYSTEM
It adopts the centralized control of the touch screen, realizes the
man-machine dialogue with the high-resolution man-machine
interface, and realizes the real-time dynamic monitoring of
operation and fault, making it more convenient to adjust and
troubleshoot
