Low Pressure Hydraulic Work Support Japanese Type Support Cylinder
for High Automation Fixtures
Features:
1.Support cylinder with clamping sleeve and double piston structure
can obtain high support force and maximum pressure withstanding of
7Mpa under lower hydraulic operation pressure (20 ~70 KGF /cm2).
2.The piston rod has small contact force on the workpiece (within
0.3-0.87kgf) , so this work support is suitable for various types
of workpiece.
3.Small size (M26~M45) , large bore piston, strong support, and
stable operation in low pressure range.
4.The installation size is the same as the product on the market at
present, which is interchangeable with other brand's product.
5.Max. operating pressure: 10 kgf/cm2
Mix. operating pressure: 4 kgf/cm2
6.Type A: Underward Clamping Support. At the initial position, the
support head is at the uppermost end under the action of the
internal spring. When working, the workpiece is pressed down by
gravity of workpiece to make support head synchronously downward.
When the workpiece is placed securely, the support head stop going
down. After the air pressure is applied, the support cylinder is
locked to provide support for the workpiece and stop running.
Type B: Upward Clamping Support. At the initial position, the
support head is at the lowermost end. After the workpiece is
placed, the support cylinder is pressurized to extend the support
head. When the workpiece is touched by the support head, the
support head stops immediately and the support cylidner is
pressurized to be locked. Then the support head provides support
and stops at the current position.
Note:
Don't place eccentric load and overload on support head.
Don't rotate the piston rod during the locking state.
Ordering Code:
CSP - 26 A L - L
1 2 3 4 5
| 1 | Series | CSP |
| 2 | Bores of Cylinder | |
| 3 | | |
| 4 | | |
| 5 | Piston spring force | L: Low spring H:High spring |
CSP Series Work Support
The chart of Operation pressure and Supporting Force
