10rpm-60rpm Speed Twin Shaft Paddle Mixer For Construction Material
System
General introduction:
Twin paddle shafts blender for production line, cement production
line, construction material system.
Twin shafts mixer is widely applied in chemical, biological, and
construction material
It can mix powder, granule, and fiber especially in battery,
construction, environmental, mineral and agricultural line. cement
mixer, fiber cement mixer etc.
Product features:
With the most powerful motor, material can be mixed evenly in the
shortest time.
It is particularly good at mixing material with big difference in
gravity, mesh size, fluidity
WORKING PRINCIPLE:
Double shaft paddle mixer is a batch mixer with two
counter-rotating shaft that are equipped with ten paddles
they overlap each other following the driven unit, Blades generate
centrifugal force during high speed rotation, spilling the material
to the upper part in the barrel then material falling down( the
vertex of material is in a so called instant non-gravity state).
Driven by the blades material is mixed back and forth: also sheared
and separated by the meshing space between the twin shafts ast and
evenly mixed in the end
When mixing:
1. The horizontal axes make the material move up and down.
2. Rotation at opposition direction of the double axes makes
materials exchange from left to right.
3. Paddle stirrers push material at angle 45 to move circularly in
the cylinder, and the materials can reach good mixing effect under
the movement of radial and axial orientation
Standard production line in construction material:
with two big raw material silos and weighing system:
1. two raw material like cement store in the big silo outside
2. convey two raw material to the weighing silo by screw conveyor
3. the weighted material goes into the funnel of bucket elevator
together with the other material like sand which is poured in by
human will be transmitted to the mixer, little additives should be
added through a small manual valve in the mixer!
4. all materials mix in the mixer for 5-10minutes
5. the mixture discharge into a silo
6. the worker starts to pack by packing machine, while another
batch can go into mixer again
7. The output is 4-6 t/h
