Hyno Energy. Wholesales of Hybrid Battery Replacement For Toyota
Carmy 6th Gen. (2007-2011), XV40. 6500mAh 244.8V
The Toyota dealership normally provides with a $4000 quote for a
battery replacement (including installation). This is actually
lower than the $5000 that others were charged in previous years.
This $4000-$5000 cost happens to be about equal to the trade-in
value of the car, making this a pretty unattractive option.
There are a number of third-party businesses that offer "renovated"
(refurbished) hybrid batteries. The renovation process is that they
find and remove failed cells from a failed battery and then replace
them with "good" used cells pulled from other failed batteries.
These cost around $1500 and come with an 18 month warranty. While
inexpensive, could not draw much comfort from relying on "good"
used cells drawn from other failed batteries.
But now you got a better option to replace the failed hybrid
battery with a good quality replacement.
General Cautions:
When the battery is out of use, please make sure the switch is off,
otherwise, it may cause leakage. When the battery is not used for a
long time, make sure the battery is open circuit that the positive
and negative poles are completely disconnected from other devices.
When the battery with the charging device is in storage, ensure
that the static current of the charging device is very small
(recommended less than 5μA), prevent the loop of the battery and
the charging device. The battery been over discharged for a long
time shall result in liquid leakage, disable to charge, and it is
difficult to restore the performance. Battery mixing is strictly
prohibited neither with different charged states for the similar
batteries nor for a dry cell, other battery of different sizes, or
brands.
Technical Specification:
| Item | Specification |
| Dimension | Length (mm) × Width (mm) × Height (mm) | 668×29 2×1 09 |
| Approximate Weight (kg) | 36 |
| Typical Capacity(mAh) | 6500 |
| Minimum Capacity (mAh) | 6000 |
| Nominal Voltage (V) | 244.8 |
| Peak Discharge (30C discharge for 10S) | Voltage ≥ 163.2V |
| Peak Charge (15C charge for 10S) | Voltage ≤ 340V |
| Continuous Discharge (15C discharge for 60S) | Voltage ≥ 183.6V |
| Specific Power | ≥1000W/kg |
| Specific Energy | ≥40Wh/kg |
| High Temperature Performance ( 55℃ 1C discharge rate) | ≥90% |
| Low Temperature Performance (-20℃ 1C discharge rate) | ≥85% |
| Charge Retention Performance (28days charge retention rate) | ≥80% |
| Working Temperature Range | -40℃ to +55℃ |
| Cycle Life (C/2 charge, 1C discharge) | ≥1000cycles |
| | |
Cautions of Battery Pack Transportation and Storage
Avoid violent vibration and external force impact, don’t cast,
roll, invert, extrude, and stack too high during handling and
transportation of battery pack.
Protect the battery pack from rain during the transportation, and
the ambient temperature is not over 55℃.
Store the battery pack in a cool and dry place and the temperature
range is 5-25℃ when you are not using it.
Maintenance regulations (Maintain the whole battery pack, and cool
with a fan during the charge and discharge process)
The SOC of our battery pack is 60%~80% when leaving the factory, in
long-term storage, battery should be stored in a charged state
(usually the SOC is 80%). Have a charge and discharge maintenance
to battery pack when the storage time is over 6 months or battery
module’s voltage is 15V,to prevent the battery performance’s
decline caused by the self-discharge. The maintenance regulations
are as follows:
- Discharge: 2A discharge to 204V (that is to say: single cell 1.0V)
- Interval: 30 minutes
- Charge: 1.3A charge for 5 hours (voltage ≥ 306V, -ΔV ≥ 0.2V and
temperature ≥50℃)
- Interval: 1hours
- Discharge: 2A discharge to 204V (that is to say: single cell 1.0V)
- Interval: 30 minutes
- Charge: 2A charge for 2.4 hours
Installation Cautions of battery pack
Notes: Installing this product should only be attempted by a qualified
technician, the voltage of the battery pack is very high, which has
the shock hazards, so when installing the battery pack, you should
wear insulating gloves and use insulated handle tools.
- Please operate according to assembly manual during the installation
of Prius battery pack.
- Do not mix our battery modules with those of other manufacturers,
or new battery modules in use with semi-used battery modules, and
don’t mix battery modules within a battery pack with those in other
battery pack.
- Don’t twist and bend battery modules and accessories when
assembling battery pack.
- Don’t connect the anode and cathode of battery module in reverse
when assembling battery pack, to prevent short circuits.
- Fasten bolts and nuts with appropriate torque, avoid loose
connection or damaging other accessories with too big torque.
Use Cautions of battery pack
- Ensure the normal operation of car management system during the use
process, and forbid over- charge and over-discharge to battery.
- As storage battery is charged by gasoline engine, so external power
supply charge is not needed. However, if the vehicle parks for a
long time, the electricity of high power storage battery will run
out. Therefore, be sure to drive the car for at least 30minutes or
16Km every several months.
- If there is leaked liquid, don’t touch the spilled liquid, because
this may be the alkaline electrolyte that hybrid battery leaks. If
skin and eyes contact to this liquid, please flush with plenty of
water at once, or if possible, wash with boric acid solution and
see the doctor at once.
Quality warranty
- The battery is guaranteed for 36 months or 50000km from the date
leaving the factory, whichever comes first.
- If quality problem occurs within the warranty period, we are
responsible for changing the damaged battery modules(Customers need
to provide related battery modules information)
- The battery is not within the warranty range in the following
situation:
- The battery damage caused by failing to in accordance with the
provisions of the transport, storage, installation and using.
- The battery damage caused by an external force (such as traffic
accidents, natural disasters) or by external short circuit during
using process.
- The battery damage caused by the out of control of BMS.
Appendix
Hunan Hi-soon Supply Chain Co., Ltd reserves the right to change
and revise Product specification without any advance notice.
