2002 Honda Civic Car Battery 6500mAh 144V 7.2 Volt Every Cell NIMH Material

Hyno Energy. Hybrid Battery Replacement For Honda Civic (1998-2005). 6500mAh 144V

Honda says to use the following procedure to disable the IMA system and isolate the high voltage battery: Turn the ignition OFF and disconnect the negative ground cable from the conventional 12 volt battery in the engine compartment. This will disable the IMA controller and prevent it from routing high voltage into the IMA system. Then remove the back seat, remove the small switch cover on the battery pack, and turn the switch OFF (down). Wait at least five minutes for the system's high voltage capacitors to discharge before working on the battery or other IMA high voltage components. If any work needs to be done on the hybrid battery junction board or control module, wear insulated gloves and use insulated tools.

Hunan Hi-soon Supply Chain Co., Ltd, is your best supplier of energy storage products with patent technology and guaranteed performance.

In addition to sustainable social change, we believe passionately in customer service, giving our employees proper training and knowledge, and making the highest quality products. We are 100% positive we are making the world a better place.

Technical Specification

The whole battery pack consisted by 20 set of above modules

Maintenance regulations (Maintain the whole battery pack, and cool with a fan during the charge and discharge process)

The SOC of our battery pack is 60%~80% when leaving the factory, in long-term storage, battery should be stored in a charged state (usually the SOC is 80%). Have a charge and discharge maintenance to battery pack when the storage time is over 6 months or battery module’s voltage is 15V,to prevent the battery performance’s decline caused by the self-discharge. The maintenance regulations are as follows:

1. Discharge: 2A discharge to 204V (that is to say: single cell 1.0V)
2. Interval: 30 minutes
3. Charge: 1.3A charge for 5 hours (voltage ≥ 306V, -ΔV ≥ 0.2V and temperature ≥50℃)
4. Interval: 1hours
5. Discharge: 2A discharge to 204V (that is to say: single cell 1.0V)
6. Interval: 30 minutes
7. Charge: 2A charge for 2.4 hours

Installation Cautions of battery pack

Notes: Installing this product should only be attempted by a qualified technician, the voltage of the battery pack is very high, which has the shock hazards, so when installing the battery pack, you should wear insulating gloves and use insulated handle tools.

1. Please operate according to assembly manual during the installation of Prius battery pack.
2. Do not mix our battery modules with those of other manufacturers, or new battery modules in use with semi-used battery modules, and don’t mix battery modules within a battery pack with those in other battery pack.
3. Don’t twist and bend battery modules and accessories when assembling battery pack.
4. Don’t connect the anode and cathode of battery module in reverse when assembling battery pack, to prevent short circuits.
5. Fasten bolts and nuts with appropriate torque, avoid loose connection or damaging other accessories with too big torque.