CERAMIC BAND HEATER FORMING EDGE MACHINE
SAFETY
Pay attention to electricity safety.
During operation, keep your hands away from the gear.
The equipment must be placed on a flat ground during installation
and cannot be shaken.
INTRODUCTION
This machine presses the metal sheet into a wave shape, which is
used for the edging of the ceramic band heater.
OPERATION INSTRUCTION
1. Power on, start switch
2. Prepare the metal sheet that need to be formed, and select the
control speed.
3. Insert the metal sheet into the front of the gear and push it
along the gear from beginning to end.
4. Turn off the power after use.
PACKING LIST
The product is equipped with a host, a power cord, and a spare gear
(there are two gears in a set).
MAINTENANCE
1. After the gear is worn, the gear should be replaced in time
2. In terms of daily maintenance, it is necessary to clean the iron
filings on the gears every day.
STORAGE
Pay attention to waterproof and moisture-proof.
TECHNICAL SPECIFICATIONS
| Size | 460x150x260mm |
| Net. Weight | 12kg |
| Voltage | 220V |
| Power | 250W |
| Material | Steel |
| Metal sheet size | Width 5-20mm; Thickness 0.3-0.8mm |
| Packing size | 52x20x30cm |
| Gross weight | 20kg |
