Product Description:
The UV weather resistance test box uses fluorescent ultraviolet
lamps and condensed water to simulate sunlight and dew conditions
respectively. For example: fading, discoloration, loss of light,
cracking, turbidity, blistering, embrittlement, strengthening,
recession and oxidation, etc.
Chamber Material:
Inner container use SUS304# stainless steel plate;
Outer shell use SUS304# stainless steel plate;
Specimen frame use stainless steel and aluminum alloy net
frame,easy access to samples;
Features:
TheUV accelerated aging test chamber can simulate environmental
conditions such as self-climate ultraviolet rays, rain, high
temperature, high humidity, dew condensation, darkness, etc. By
reproducing these conditions, it is merged into a cycle, and it
automatically executes the number of cycles completed. In this
process, the equipment can be used for automatic monitoring of
blackboard temperature and water tank temperature; by configuring
irradiance measurement and control device (optional), the
irradiance can be measured and controlled, and the irradiance is
stable at 0.76W/m2/340nm or specified setting. Fixed value, greatly
extending the service life of lamps.
Mainframe Working Environment
*Power requirement:220V±5%,single-phase three-wire,50Hz,8A,request
10A slow-blow fuse;
*Environment:5~35℃,0~80%RH,good ventilation,Indoor environment
cleaning;
*Area of work about 234*353cm;
*Water draining:A drain is needed on the floor near the main engine
ease movement,foot wheel is installed at the bottom of the
instrument,After the position is fixed, the position of the test
machine is fixed with a U-ring;
*For the convenience of heat dissipation and maintenance,The
installation of the equipment must meet the following conditions;
*Adequate maintenance space should be maintained between the
equipment and walls or other equipment after installation and
adjustment;
*The environmental temperature of the installation site should not
change sharply；
*It should be installed on horizontal ground(Use a level meter to
confirm the level on the ground during installation)；
*It should be installed in places without direct sunlight；
*It should be installed in a well-ventilated place；
*Should be installed away from combustible materials,explosive and
High temperature source；
*It should be installed in a little dusty place ;
*Install close to the power source;
