Common Mode Choke Inductors Customization Toroidal Inductor
What is an inductor
An inductor is characterized by its inductance, which is the ratio
of voltage to the rate of change of current.
The inductor consists of a coil of conducting material- insulated
copper wrapped around a core of a ferrimagnetic material which is
called an "iron core" inductor.
What is inductance?
Inductance is the tendency of an electrical conductor to oppose
changes in the current flowing through it. L stands for inductance,
and Henry is the SI unit of inductance.
Product Features:
1. Complaint to RoHS
2. Wire Spec: Customization
3. Inductance: Customization
4. Magnetic Coil:Customize
5. High operation frequency.
6. High quanlity choke and inductor.
7. Low magnetic leakage.
8. Good thermal stability.
9. Low DC resistance & Low loss.
10. Excellent current choking performance.
11. High saturation materal & high efficiency.
Application of inductors
Inductors are widely used in analog circuits and signal processing.
Applications range from the use of large inductors in power
supplies to small inductors of ferrite beads or toris installed
around the cable to prevent radio frequency interference in
transmission along the wire.
Inductors are usually used in tuning circuits, induction motors,or
used as sensors, filters,chokes,ferrite beads,or used as relays.
Inductor’s charactor
The flow of current produces a magnetic field, and the change in
the magnetic field produces the opposite current.
Convert electrical energy into magnetic energy and store it.
Direct current can pass through, but alternating current does not
pass easily at higher frequencies.
Our Advantage
1.Design and prototype automation basis in Dongguan which is the manufacturing center of
South China.
2.10+ dedicated and experienced engineers and designers in R&D
department.
3.Manufacture Center in Sichuan Province which is close to Yangzi
River wharf and Chongqing Airport .
4.10+ production lines, 100+ experienced managers and workers.
5.Help customers quickly design their ideas into mass production
solutions, and complete prototype design, development and
verification.
