Plastic Housing 12V 100W IP67 Waterproof SMPS For LED Lighting

JSPP-100 Series LED waterproof power supply
Features:
· Constant voltage design
· Universal AC input / Full range
· Withstand 300VAC surge input for 5 seconds
· Protections: Short circuit / Overload / Over voltage
· Cooling by free air convection
· Fully encapsulated with IP67 level(Note.8)
· Fully isolated plastic case
· Class II power unit, no FG
· Class 2 power unit
· Pass LPS
· Suitable for LED lighting and moving sign applications(Note.7)
· 100% full load burn-in test
· Low cost, high reliability
· 3 years warranty

NOTE:
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 ℃ of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Derating may be needed under low input voltage. Please check the static characteristics for more details.
5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time.
7. Suitable for indoor use or outdoor use without direct sunlight exposure. Please avoid immerse in the water over 30 minute.
8. The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.