Simplex CWDM MUX
GEZHI Multiplexer (MUX) work with demultiplexer (DEMUX) on the
other side for single directional data transmission over one fiber.
GEZHI Photonics 8CH CWDM Mux/Demux Module is a passive technology,
it allows for any protocol to be transported over the link, as long
as it is at a specific wavelength (i.e. T1 over fiber at 1570nm
transported alongside 10Gbps Ethernet at 1590nm). This allows for
long-term future proofing of the networking infrastructure because
the multiplexers simply refract light at any network speed,
regardless of the protocol being deployed.
GEZHI Photonics provides a complete portfolio of CWDM Mux Demux and Optical Add Drop Multiplexer(OADM) units to suit all applications such as: Gigabit & 10G Ethernet,
SDH/SONET, ATM, ESCON, Fibre Channel, FTTx and CATV. And we provide
optional port configurations such as: Express Port, Monitor Port,1310nm passband port and 1550nm port for these multiplexers according to customer
choice.
Front Panel Details
A Common port:
- LC, SC, ST and FC connectors available.
B Standard port 1310nm:
- Allows a legacy 1310nm signal to pass. That is to say, it can carry
LR optics, LX optics etc.
- LC, SC, ST and FC connectors available.
C Standard port 1550nm:
- Allows a legacy 1550nm signal to pass. That is to say, it can carry
ER optics, ZR optics, LX optics, ZX optics etc.
- LC, SC, ST and FC connectors available.
D Mux/Demux port for specific wavelengths:
- LC, SC, ST and FC connectors available.
- Compliant with the ITU G.657A1 standard as default.
E Express port:
- Enables the cascading of two CWDM mux/demux modules, doubling the
channel capacity on the common fiber link.
- Channel Isolation is 15dB as default, 16dB ~40dB available on
request.
- LC, SC, ST and FC connectors available.
F Monitor port:
- Connects measurement/monitoring equipment, such as power meters or
network analyzers, to the module outputs.
- When finished monitoring, disconnect the instruments and the
network is left undisturbed.
- LC, SC, ST and FC connectors available.
- Tap percentage is 5% as default, 1%, 2%, 3%, or 10% available on
request.
NOTE:
Actual layout depends on the chosen connector type as well as other
factors. However, the principal scheme stays the sameWe provide
optional port configurations such as: Express Port, Monitor Port,
1310nm passband port and 1550nm port for these multiplexers
according to customer choice, When using with 1310nm legacy
SDH/SONET, CWDM wavelengths 1270, 1290, 1310, 1330 and 1350nm
should not be used.When using with 1550nm legacy SDN/SONET, CWDM
wavelengths 1510, 1530, 1550, 1570 and 1590nm should not be used.
