100 Non-Asbestos Fireproof Facade Decorative Exterior Wall Panel
Reinforced Fiber Cement Board
Main Features:
1. 100% Asbestos Free
2. Excellent Fire Resistant
3. Excellent Moisture / Water Resistant
4. Good Heat and Sound Insulation
5. High Strength
6. Stable Dimensions
7. Durability and long service life
Advantages:
1. Environmental friendly,no VOC gas when installation
2. Large effect,elegant appearance,less gap and favorable to
cleaning
3. Low thermal conductivity and favorable to heat insulation and
energy saving
4. Surface diffuse reflection and not reflective
5. Good durability and long service life
6. Bright apperance and rich color gives us a feeling of
cleanliness and warmth
Product Introduction:
It is strong and flexible board composed of cement,refined
ores,reinforced cellulose fiber as the main materials.
It's made of autoclaved process under high temperature and pressure
which generates a light-weight,durable and smooth-faced board for
various applications of interior and exterior decoration.
Product | Compressed Fiber Cement Board |
Dry Density(g/cm3) | 1.3-1.4 |
Water absorption (%) | 28-33 |
Wet expansion (%) | 0.2 |
Water Content(%) | 7-13 |
Bending Strength(Mpa) | 16-22 |
Shrinkage rate(%) | 0.1-0.15 |
Frost resistant | No delamination and crack after 25cycles under freezing and thawing |
Water penetration | No water drop on the board surface |
Product Application:
1. Fire-proof structure
2. Fire-proof ceiling
3. Billboard
4. Water-proof Baffle
5. Washboard
6. Flue board
7.Access foor
8.Cabinets etc.
(1). Thickness: 4-24mm
(2). Standard size: 1220*2440mm or 1200*2400mm
(3). Note: other specification is available,such as
915mm*1830mm,1220mm*3000mm
1. Galvanized Metal Frame
a.The top and bottom keels are fixed respectively top floor and on
floor with expansion bolts.
b.The vertical keel should be aligned well according to the
requirement (generally being 612 mm) with
laterally supporting keel installed.
2. Board Material Package Fixed
a. Cutting the board material to the dimensions needed (about 10mm
lower than wall height)
b. Board material is fixed on keel in anchoring seam way with
tapping screw: the interval of tapping screw is generally
about 200~250mm with screws sinking 0.5mm under the board face.
c. The expansion seam of about 4mm between boards should be kept.
d. The shrouding should be fixed from the middle to the four sides
and cannot be operated at multipoint simultaneously
to avoid generating inner stress to make board material bucking.
e. Before board being packaged and fixed, depending the needs,
glass cotton or rock cotton can be filled
