HXE-TH250 Annealing machine for Intermediate copper wire drawing
I. Quick details
TH250 Annealing machine for intermediate copper wire drawing is
used to annealing wire from 0.4mm to 1.2mm.
II. Main technical parameter
1. Usage single bare copper wire annealing
2. Applicable wire diameter 0.4mm-1.2mm, Speed 1200m/min
(Adjustable)
3. Annealing method DC. Three-section annealing
4. Annealing current DC 1500A
5. Annealing voltage DC 55V
6. Steam quantity 12kg/h
7. Cooling water capacity 400L/min
8. Compressed air capacity 0.4-0.6Mpa, 30L/min
9. Power source Customize
10. Direction Customize
11. Cooling method Water
12. Protection by Steam
13. Driving by AC 5.5KW Motor, Chinese classical brand WN.
14. Inverter control 5.5KW, Classical Brand Inovance
III. Advantage and after-sale service
A: Advantage
(A1). HENGXIE has some world famous parts suppliers, has special
lubrication system for the gears and bearing.
(A2). Body and other key components and parts are produced by our
own factory , quality is reliable.
(A3). Our company’s developing process in more than 10 years.
(A4). DC. three-section annealing
B: After-sale service
Our company for all machine product, since the shipment date, our
company free after sale maintenance service guarantee period is:
(B1) 1 year for mechanical part.
(B2) 6 month for electrical part.
Under these situation mentioned, the Seller will not take
responsibility, but if the Buyer agree, will charge fees
accordingly to repair the machine.
A. Due to wrong operation while shipping.
B. Due to Buyer`s wrong preparation that may cause damage to the
machine.
C. Due to Buyer`s wrong operation that may cause damage to the
machine.
D. Not in the consuming part list.
E. After agreement are made for the shipping, for any damage, Buyer
should inform Seller in letter form to repair in seven days, If
beyond the dare, Seller shall take no responsibility.
F. For any other failures due to acts of God (such as lightning,
typhoon, earthquake, riots, war, fire or flood) and other factors
that will cause damage, Seller shall take no responsibility.
G. Seller guarantee provide long term support regarding the parts
and teach. After warranty, will charge accordingly.
IV. Machine structure
Annealing method is DC Three section annealing, there are three
contact capstans, as Pre-Heating, Annealing and Drying. For drawing
machine part, there is belts that connection from the Fix-speed
capstan to the Annealer machine to achieve the transmission, as
keep same speed.
Connect the Up capstan and Down capstan with Positive and Negative
power, to make the wire in a short circuit, to achieve the heating.
There is annealing plate to auto track and adjust the speed and
annealing voltage.
To achieve fast coolant to make the wire soft(Annealing), the Down
capstan is immersed into the coolant water(There is a water tank in
the bottom of the Annealer machine), coolant water with 0.5%
anti-oxidation. With the Pump to pump the coolant water through all
pipes and valves, half sealed annealing door. Adjust the valves to
adjust the coolant water in certain height.
To make sure the wire no oxidation, in the annealing protection
pipe has steam (Buyer self will prepare Steam generator).
In the drying section, has a blowing device (Require two dies,
Buyer self prepare), by compressed air (Buyer self prepare Air
compressor) to blow the water on the surface of the wire.
