Feeding Unit
• Pile tray with handle allowing manual lateral correction of
the pile during production
• Stream-wise feeding system with a highest speed of 120
sheets per minute
• 2 suction cups each for lifting paper, 2 suction cups for
moving paper
• Height and angle of suction heads are easily adjustable
• Electronic safety devices preventing feeder pile from over
ascending
• Micro-adjustment is available for transversal positioning
of pile table
• Precision double-sheet detector
• Easy changeover of pull and push side guides simply by turning a
bolt without the need of removing
and replacing complete side guide
• 2 front guides with micro-adjustment and the side guide is
adjustable by wheel handle
• Photo-electric detector with automatic stop system on feeding
table in case of paper jam
• Separate drive controls of feeding unit & the main machine for
easy make ready
• PLC and electronic cam for timing control
Diecutting Unit
• Siemens main motor controlled by Schneider
inverter control
• Micro-adjustment of cutting force by worm gear
driven by motor and controlled by touch screen
• The pressure accuracy can be up to 0.01mm
• Crank shaft made of 40Cr steel
• Machine frames made of Q235-A Steel, upper and
lower platens made of QT60 ductile iron with resin
coated sand with Meehanite Die Cast Iron
Technology
• Cutting chase turn-over device
• Overload protection device with torque limiter for the highest
safety of operator and equipment
• 7 sets of gripper bars with grippers made of lightweight and
durable aluminum alloy with ultra hard
coat and anodized finish ensure accurate and consistent paper
registering
• After long run test and delivered in pairs, main gripper, chain
from Subaki, Japan
• High pressure index drive system for gripper bar positioning
control
• Pneumatic lock-up and release of cutting chase
• Centerline system for quick job changeover
Stripping Unit
• 3-action movement structure with upper, middle and lower
stripping frame to facilitate die change
• Stripping pins or male/female die can be used for different
stripping jobs
• Match with the centerline registration system in the
diecutting section, the same system also apply to the
stripping system to minimize changeover time. Accurate
positioning can increase production efficiency
• The up/down movement of upper stripping frame is
controlled by motor which makes adjustment easier
Delivery Unit
• Safety photo-electric devices preventing over-
ascending and over-descending of delivery paper
pile
• Adjustable depressor brush helps unloading paper
from grippers and piling up paper
• High pile design up to 1020mm
• Automatic auxiliary belt table available for non-stop
delivery
• Feeder movement and speed control can be
adjusted in the delivery unit
Electric Parts, Operator Interface and Safety Detector
• The high speed Japanese industrial Omron PLC
system
• Omron operator interface with touch screen
• Omron Electronic cam switch and encoder
• Electronic detectors, micro switched and photo-
electric cells controlled by PLC on entire machine
