*Removal Warning & Notice:
Vent all air pressure from the air suspension system prior to
disconnecting or removing any air suspension components. It is
dangerous to remove air suspension components while under pressure.
Failure to follow this instruction may result in serious personal
injury.
Any air spring which is unfolded must be refolded prior to being
installed in a vehicle. Refer to the procedure. An incorrectly
folded air spring could rupture, altering the handling
characteristics of the vehicle. If a vehicle has been driven with
an incorrectly folded air spring, a new air spring must be
installed. Failure to follow these instructions may result in
serious injury to vehicle occupant(s).
Failure to observe the following instructions may result in a
sudden failure of the air spring or suspension system.
Any rear spring which is unfolded must be refolded prior to being
installed in a vehicle.
The air spring refolding procedure should only be used for an air
spring which has never supported the vehicle's weight while in the
incorrectly folded position.
Incorrectly folded air springs found on vehicles during
pre-delivery inspection or after use must be installed new.
Do not attempt to inflate any air spring which has been collapsed
while uninflated from the rebound hanging position to the jounce
stop.
When installing a new air spring, care must be taken not to apply a
load to the suspension until springs have been inflated using the
air spring fill procedure.
After inflating an air spring in the hanging position, it must be
inspected for correct shape.
1.NOTE: The vehicle must be positioned on a suitable lifting device
prior to deflating the air suspension system.
With the vehicle in NEUTRAL, position on a hoist until the wheel
and tire assemblies are slightly above the ground.
2.Using the scan tool, vent the air springs.
3.Remove the air spring retainer.
4.Detach the air spring from the rear axle.
5.Remove the air spring in the following sequence.
1.Disconnect the air spring solenoid electrical connector.
2.Compress the quick connect locking ring and pull out the air
tube.
3.Remove the air spring.
Guangzhou Viking Auto Part Ltd is a Chinese supplier that has been
in the business of manufacturing air springs for 14 years. We have
established ourself as a reliable and trustworthy manufacturer of
high-quality air springs, air pumps, and air shocks for truck
trailers and buses. Our company has a 30,000 square meter factory
and an in-house lab, which ensures that our products meet strict
quality standards.
Welome to contact us.
Contact: Cindy Huang
wechat: 0086-13928831072
whatsapp:0086-13527661764
email:sales@vkairspring.com
