LDX-020A Factory direct sales Automatic TCT saw blade grinding
machine
What are the preparations before grinding the gear grinding
machine:
1,Measure the outer diameter and center hole of the saw blade and
select the centering washer, install the saw blade on the saw blade
seat, and then lock it with the rolling nut of the saw blade seat,
then relax the fixed locking screw of the saw blade seat, and then
move the saw blade seat to align the size of the outer diameter of
the saw blade with the corresponding scale of the saw blade seat,
and then lock the fixed screw.
2,If the saw blade has broken teeth or a new tooth, it must be
used. In general, it is easier to grind with guide pieces, and
guide pieces should be used as much as possible.
3,If the rotation of the saw blade is not properly relaxed, the
forward displacement of the saw blade will not be allowed at this
time, so when the saw blade is installed, rotate the circular saw
blade with the left hand counterclockwise direction to test the
rotation tightness, if the tightness is improper, adjust the
anti-loosening nut with the M17 open wrench to make the rotation
tightness of the saw blade appropriate.
| Technical parameters: |
| Processing saw blade diameter range: ￠200- ￠1200mm |
| Saw blade aperture: ￠10-220mm |
| Saw blade thickness (steel plate): 1-12mm |
| Tooth pitch: 7-110mm |
| Tooth surface angle: 5 degrees to+20 degrees |
| Tooth top back angle: 1-20 degrees |
| Left and right inclination of teeth: tooth tip/tooth surface 20
degrees |
| Blade grinding stroke range: maximum 25mm (adjustable) teeth/minute |
| Grinding speed: 0.5-6mm/s |
| Working speed: maximum 20 teeth/minute |
| Grinding wheel size (outer diameter x hole): (￠ 125mm x ￠ 32mmX1mm) |
| Negative chamfer grinding: -15 degrees |
| Grinding wheel linear speed: 26m/s |
| Flow rate of coolant water pump: 501/min |
| Volume of coolant cylinder: 85L |
| Total power: 1.85 kW |
| Voltage: three-phase 380v |
| Mechanical weight: 800KG |
| Mechanical dimensions (length x width x height): 1600X1100X1800mm |
|
| Technical features: |
|
| 1. This equipment can grind aluminum TCT cutting TCT saw blades,
woodworking saw blades, and large alloy saw blades. It is easy to
operate and can fully extend the service life of alloy saw blades.
Each blade can be reused 15-30 times. This equipment has received
praise from many buyers. |
