Introduction
The cross-arm 13 holes is an angled bar section used for roll-out
overhead parallel lines. Equipped with 13 holes this pole bracket
mounts on a bracket compatible with the pole to be equipped. Its
role is to enable fastening points for deadending and suspension
applications.
Thanks to its 820mm length, this pole hardware preserves cable
against environmental constraints by offsetting them from the
poles.
Crossarm 13 holes can receive multiple drop cross-arm brackets at
it extremity, enabling thus to anchor drops perpendicularly to the
main network.
Application
Cross-arm with 13 holes can be used for pole, extension bracket,
polt mounting on fiber optic and copper networks
Up to 8 routing cables
Cross-arm 1 holes can be used us strut to creat an offset with a
cross-arm with 13 holes
Cross-Arm 11 holes Characteristics
Material: hot dip galvanized steel
Hole spacing: 60mm
Dimensions: 820x40x40mm
Installation:
on non drillable poles (concrete, composite,...)
on drillable poles (wooden)
on pre-drilled poles (steel, concrete,...)
on extension brackets (REFO,...)
Our service
1, Product consulting service
2, Cost-saving advice
3, Fast response speed to needs
4, Professional and complete reference documents
5, Safe and cheap transportation solutions
6, 7*24 Hours After Sales Service
Contact us
Email: sales@getotelecom.com
Whatsapp/Tel: 86-18600124328
Web: www.getotelecom.com
Company
Introduction
The cross-arm 13 holes is an angled bar section used for roll-out
overhead parallel lines. Equipped with 13 holes this pole bracket
mounts on a bracket compatible with the pole to be equipped. Its
role is to enable fastening points for deadending and suspension
applications.
Thanks to its 820mm length, this pole hardware preserves cable
against environmental constraints by offsetting them from the
poles.
Crossarm 13 holes can receive multiple drop cross-arm brackets at
it extremity, enabling thus to anchor drops perpendicularly to the
main network.
