FL5080 Digital Computer CTP Machine High Energy Power 256 Channels LV Technology

Model: FL5080

Description: Digital computer to flexo plate imagesetter CTP machine; A full-size 50-inch * 80-inch flexo plate-making machine

Description

FL5080 is designed based on a high energy power fiber laser and independent control of 256 channels LV technology. It is a new breakthrough in the limitation of energy power. Together with laser distance detection and voice coil motor dynamic autofocus device, it can ensure an accurate focus on the media substrate surface disregarding the variance on flexo plate material. This technology know-how is unique.

Features and technology

Using a high energy power fiber laser device, at 5080dpiit only takes 30 minutes to output a full image size of a 50inchx80inch plate. It can also allow to increase productivity by 10% for urgent needs. In this way, the customer can meet the deadline of some urgent jobs.

256 channels independent modulating technology allows the laser to split into 256 channels with control of each channel which greatly increases productivity. The laser spot shape is a rectangle type which can deliver a much better dot quality and performance of image output.

The H256 laser head uses a new high-power magnification optical system to achieve a 5080 dpi optical resolution.

At 5080dpi, it can image a slant or circular line as fine as 15um; for vertical and horizontal lines, it can be as fine as 5um. Each image pixel is very sharp and clear. This increases the color fidelity by 30%.

This new generation of Light Valve Device can also allow to raise the resolution to 10160dpi. At this super high resolution, the laser spot size is 2.5umx2.5um and can image 5 or fewer um lines.

The LV head can also support 2540 dpi output. If the requirement of imaging output is not critical, the mode of output can be adjusted to double line overlapping exposure which can greatly increase productivity to 150%.

A voice coil motor device is used for dynamic autofocus function. This can ensure accurate focus during exposure on the non-uniform surface of the flexo plate.

Double lines and triple lines overlapping functions can allow the LAMS ablation with superior image quality and efficiency for flexo plate exposure.

Instant temperature monitoring and pre-calibration of the laser head can make sure the laser exposure is stable and reliable.

Technical data

Square spot vs. Round spot

When using a round dot spot for imaging, the diameter of the spot size should match the image dot size. For example, for 5080dpi, the image dot pixel size is 5umx5umwhich is like a square area. So if using a round light spot size of 5u diameter, the light cannot expose the four corners of the square area. In order to ensure the light spot can expose the full image pixel area, the round dot spot diameter needs to be a larger size which is equivalent to the diagonal length of the square area. That is 7.07um which is 1.414 times the dot size as shown below.

A 5um diameter spot size cannot expose the full square area while a 7um diameter spot size causes unwanted exposure on some areas over overlapping each other. This creates an irregular image with an arc-shaped edge.

So some optics development fellows try to select the optimum diameter of light spot instead of using a 7.07um diameter size. However, no matter what diameter or dot size is chosen, there is still some deficiency in quality.

For a rectangle dot shape, it allows development fellows to choose a 5umx5umum size spot which completely exposes the full square area as shown below.