How to use Square Brass Angel Valve
To use a square brass angle valve, follow these steps:
Identify the Valve: Locate the square brass angle valve in your
plumbing system. It is usually installed on the water supply line
leading to a faucet, toilet, or other fixtures that require water
control.
Shut off the Water: Before using the valve, make sure to shut off
the water supply to the fixture you want to work on. Look for a
separate shut-off valve located upstream from the angle valve and
turn it clockwise to stop the water flow.
Determine the Flow Direction: The square brass angle valve has an
inlet and an outlet. The inlet is where the water flows in, and the
outlet is where it comes out at a 90-degree angle. Ensure you
understand the flow direction to control the water correctly.
Open the Valve: To allow water flow, turn the valve handle
counterclockwise or in the direction indicated for opening. As you
turn the handle, the internal mechanism will lift, allowing water
to pass through the valve.
Adjust Water Flow: Angle valves usually have a quarter-turn
mechanism, so you can adjust the water flow by turning the handle
partially or fully. Turn it counterclockwise to increase the flow
and clockwise to reduce or stop it.
Close the Valve: To stop the water flow, turn the valve handle
fully clockwise or in the direction indicated for closing. Ensure
the valve is tightly closed to prevent any water leakage.
Check for Leaks: After using the valve, check for any water leaks
around the valve or the connected fixtures. If you notice any
leaks, make sure the valve is fully closed and that the connections
are properly sealed.Remember, if you are unfamiliar with plumbing
systems or are unsure about making adjustments, it's best to seek
the assistance of a professional plumber to avoid any potential
issues. Plumbing can be complex, and improper handling may lead to
leaks, water damage, or other problems.
