74AVCB164245ZQLR Programmable Logic ICS Voltage Levels 16B Dual-Supply Bus Transc

74AVCB164245ZQLR Programmable Logic ICS Voltage Levels 16B Dual-Supply Bus Transc

FEATURES

• Member of the Texas Instruments WidebusTM Family

• DOCTM Circuitry Dynamically Changes Output Impedance, Resulting in Noise Reduction Without Speed Degradation

• Dynamic Drive Capability Is Equivalent to Standard Outputs With IOH and IOL of ±24 mA at 2.5-V VCC

• Control Inputs VIH/VIL Levels Are Referenced to VCCB Voltage

• If Either VCC Input Is at GND, Both Ports Are in the High-Impedance State

  
  

DESCRIPTION

This 16-bit (dual-octal) noninverting bus transceiver uses two separate configurable power-supply rails. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.4 V to 3.6 V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.4 V to 3.6 V. This allows for universal low-voltage bidirectional translation between any of the 1.5-V, 1.8-V, 2.5-V, and 3.3-V voltage nodes.

The SN74AVCB164245 is designed for asynchronous communication between data buses. The device transmits data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control (DIR) input. The output-enable (OE) input can be used to disable the outputs so the buses are effectively isolated.

The SN74AVCB164245 is designed so that the control pins (1DIR, 2DIR, 1OE, and 2OE) are supplied by VCCB.

To ensure the high-impedance state during power up or power down, OE should be tied to VCCB through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.

This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down. If either VCC input is at GND, both ports are in the high-impedance state.

ORDERING INFORMATION