Lithium Battery Extrusion Needle Punch All-In-One Machine
Introduction:
1. For cylindrical batteries, the longitudinal axis of the extruded
battery should be parallel to the two plates of the extrusion
device
2. For square and pouch batteries, only the wide surface of the
battery is extruded
3. For coin-type or button batteries, the upper and lower planes of
the batteryare squeezed parallel to the flat plate. The acupuncture
test should be carriedout in an environment of 20 "C + 5C, the
battery is placed flat on the fixture, andthe non-corrosive steel
needle with a diameter of 3-8mm is inserted into thecenter position
of the battery surface at a speed of 10mm/s-40mm/s, and thetest
results are observed at any time, and the battery does not explode
anddoes not fire as qualified. The battery extrusion testing
machine adheres to GB31241-2014 and other standards
Meet standard:
GB/T21966-2008(IEC62281:2004)
GB/T1952111-2005EC62133-2012
SJ/T 11169-1998(UL1642:1995)
SJ/T11170-1998(U12054:1997)
GB/T 8897.4-2008(IEC60086-4:2007)
Extrusion Parameters:
1 .Extrusion degree: the extrusion pressure reaches 13+0.78kN, and
it can be stopped when the maximum value is reached
2. Box material: inner box stainless steel, outer box cold-rolled
steel plate spray treatment 10 Features: The rear side of the box
is designed with exhaust vent and pressure relief device, and the
box is equipped with lighting 11.Test space: 300x300x300mm (length
x width x height)
Specifications:
| NO | Item | Parameter |
| 1 | Test space | 300x300x300mm (length x width x height) |
| 2 | Force range | 1~20kN(adjustable) |
| 3 | Extrusion stroke | 300mm |
| 4 | Box material | inner box stainless steel, outer box cold-rolled steel plate spray
treatment |
| 5 | Features | The rear side of the box is designed with exhaust vent and pressure
reliefdevice,
and the box is equipped with lighting |
| 6 | Steel needle | 3mm 5mm high temperature resistant tungsten steel needle,ength
of100mm (can be specified) |
| 7 | tinerary | 200mm |
| 8 | Clampable battery distance | 200mm |
| 9 | Unit conversion | Kg,N, LB |
| 10 | Needle punching speed | 10~40mm/s(adjustable) |
| 11 | Needle prick force value | 1~300Kg |
| 12 | Force value display | PLC touch screen display |
| 13 | Data acquisition | 1 channel each for voltage and battery temperatureservo |
| 14 | Drive mode | motor control stroke adjustable, speed adjustable box bodymaterial:
iner box stainless steel, outer box cold-rolledsteel plate |
Details:
