3A210-06 1/8'' 3 Position 2 Way Exterior Control Air Pilot Valve
Installation & Usage:
1.Before installing, be sure the valve hasn't been damaged via
transportation.
2.It's suggested to use the medium lubricated by 40μm filter
element. Be aware of the flow direction and port size.
3.Please notice whether the installation condition accords with
technical requirements (such as“act-uation frequency”, “working
pressure” and “scope of application temperature”), then the
equipment can be installed and used.
4.Notice the flow direction of air during installation, P is the
air intake, A (B) is the work port and R (S) is the exhaust outlet.
5.Take measure to avoid vibration and frozen.
6.Firstly press the base gasket into the base, and then connect the
base with the valve body by the affiliated screws. The base gasket
can be pressed into the installation places that are not used
temporarily, and then seal them with affiliated blank cap. When the
system expands, take the blank cap off and install relative air
valves;
7.To keep the dust away, please use the silencer for the exhaust
ports. Never forget to install dirt-proof boot in air intake and
outlet during dismounting.
Technical Data:
| Model | 3A210-06 | 3A220-06 | 3A210-08 | 3A220-08 |
| Fluid | Air(to be filtered by 40 μ m filter element) |
| Acting | Exterior control |
| Port Size | In=Out=1/8'' | In=Out=1/4'' |
| CV | 0.78 | 0.89 |
| Valve Type | 3 Port 2 Position |
| Operating Pressure | 21~114psi(0.15~0.8MPa) |
| Temperature | -20~70℃ |
| Material of body | Alumium Alloy |
| Max. frequency | 5 cycle/sec |
Dimension Diagram:
Brando Supply:
1.Solenoid Valve:
Pulse Jet Valve: Goyen Type Pulse Jet Valve, SBFEC Type Pulse Jet
Valve, ASCO Type Pulse Jet Valve , Turbo Type Pulse Jet Valve.
Direct Acting Solenoid Valve:Brass Solenoid Valve, Stainless Steel
Solenoid Valve, Plastic Solenoid Valve and etc.
Refrigeration Solenoid Valve:Castel Type Solenoid Valve, Danfoss
Type Solenoid Valve.
2.Repair Kit:Solenoid Coil, Solenoid Armature/Stem, Diaphragm Repair Kit and
etc.
Focus on your demands, Offer you best solution:
√ Contact us if some points you have doubt
√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for
√ Contact us if you are doing designing
Welcome to your any question and inquiry!
