Two-Part Urethane Mold Rubber 60 Shore A Liquid Polyurethane Rubber
For Architectual Concrete Molds
Product Description
Polyurethane rubber consists of A&B component, which, after
mixing, cure at room temperature to flexible, high-strength, mold
rubber. It can make durable molds for casting plasters and waxes,
cement.
Character:It has excellent processing properties, solid in common
temperature, shorter gel time, and regulating color by adding
pigment. The ware has good properties of abrasive resistance,
hydrolysis resistance, transparent, good resilience, stable
dimension.
A | Type | MCPU-60A |
| Appearance | Colorless or light yellow transparent liquid |
| Viscosit(y mPa·s) | 1800±300 |
B | Type | MCPU-60B |
| Appearance | Light yellow liquid |
| Viscosity(mPa·s) | 500±200 |
| Ratio A:B(mass ratio) | 1:1 |
| Working time /minS | 20-25(variable) |
| Appearance | Light yellow |
| Hardness (shore A) | 60±2 |
| Tensile strength/MPa | 5-8 |
| Elongation at break/ % | 300-400 |
| Tear strength/(kN/m) | 20-25 |
| Rebound/ % | 30-35 |
| Specific gravity(25℃)(g/ cm3) | 1.18 |
Applications
Suitable for making the mould of concrete panel & cultured
artificial stone. It also applies to electrical equipment potting,
rubber rollers, Ski and snowboard, rubber plates, rubber wheels,
shoe models and others.
Using Instructions
NOTE: To ensure thorough coverage, lightly brush the release agent
with a soft brush over all surfaces of the model. Follow with a
light mist coating and let the release agent dry for 30 minutes.
Because no two applications are quite the same, a small test
application to determine suitability for your project is
recommended if performance of this material is in question.
Measuring & Mixing...
Liquid urethanes are moisture sensitive and will absorb atmospheric
moisture. Mixing tools and containers should be clean and made of
metal or plastic. Materials should be stored and used in a warm
environment (73°F/23°C).
IMPORTANT: Stir Part B thoroughly before dispensing. After
dispensing equal amounts of Parts A and B into mixing container,
mix thoroughly for at least 3 minutes making sure that you scrape
the sides and bottom of the mixing container several times.
Pouring, Curing & Performance..
For best results, pour your mixture in a single spot at the lowest
point of the containment field. Let the rubber seek its level up
and over the model. A uniform flow will help minimize entrapped
air. The liquid rubber should level off at least 1/2” (1.3 cm) over
the highest point of the model surface.
Curing - Allow rubber to cure a minimum of 16-24 hours at room
temperature (73°F/23°C) before de-molding.
Using The Mold - If using as a mold material, a release agent should be applied
to the mold before each casting.
Performance & Storage - Fully cured rubber is tough, durable and will perform if
properly used and stored. The physical life of the rubber depends
on how you use it.
Package:20Kg/drum, 200kg drum
Shelf life
For best results, store products in a ventilated place with
unopened containers at room temperature (60-90°F/15-32°C).
Use products within six months.
