GI Wire Brickforce Mesh Used In Building Welded Wire Mesh Machine
Welded Wire Mesh Machine Description
The welded wire mesh machine is full automatic.The warp wire and
the weft wire is feeding by wire coils.Put the wire coils on the
wire racks ensure the smooth material feeding of the machine.Set
the length of the mesh roll you need on the counter of the control
panel in advance.The machine will stop automatically.Then the
worker cut the mesh with electric scissors and unloaded the mesh
roll from the machine.
Welded Wire Mesh Machine Technology
1. The welded wire mesh machine adopts the integrated circuit board to control the SCR module,
adjust the welding current and welding time, the welding is more
firm and the welding effect is better.
2. The two ends of two wire coils can be welded by butt welding
machine, so that the mesh roll is more beautiful.
3. The welded wire mesh machine adopts separate times welding,reduced
the load of the power source, making energy efficient.
4. The wire drawing shaft of the machine is made of heat-treated 45
steel, which is very wear-resistant. This accessory does not need
to be replaced.
5. The machine belong to resistance welding machine.All cross welds on the weft are welded at
the same time.
Welded Wire Mesh Machine Welding Electrode
The welding electrode belongs to wearing parts.It is made of high
quality high chromium copper,can be used for more than 2
years.Compared with the ordinary brass bar, our high-quality
welding electrode have long service life and good welding effect.
The production cost is reduced.
