Double Acting Long Stroke Pneumatic Air Cylinders Stainless Steel
Pneumatic cylinders, also known as pneumatic actuators, operate by
using the force of compressed air against a moving piston to create
mechanical movement. Pneumatic cylinders are specified depending on
the mass of the load being moved, the distance it is to be moved
over and the time required to move the load.
Single acting and double acting pneumatic cylinders are the common
options available. In single-acting pneumatic cylinders, air forces
the piston against a spring which returns the cylinder to its
default position when the air is removed. In double-acting
pneumatic cylinders, air is used to push the piston one way and to
return the cylinder to its default position. Air is applied on the
opposite side of the piston while on the original side and the air
is allowed to exhaust.
Specifications of MA Series Pneumatic Cylinder:
| Bore Size (mm) | 16 | 20 | 25 | 32 | 40 | 50 | 63 |
| Acting Type | MSA / MTA | Single Acting | - |
| MA / MAD / MAJ | Double Acting | - |
| MAR | - | Double Acting |
| MAC / MACD / MACJ | Double Acting with cushion |
| Fluid | Air (to be filtered by 40μm filter element) |
| Operating Pressure Range | Double Acting | 0.15 to 1.0 MPa (1.5 to 10.0 bar) (22 to 145 psi) |
| Single Acting | 0.2 to 1.0 MPa (2.0 to 10.0 bar) (28 to 145 psi) |
| Proof Pressure | 1.5 MPa (15 bar) (215 psi) |
| Temprature (℃) | -20 to +70 |
| Speed Range (mm/s) | Double Acting: 30 to 800, Single Acting: 50 to 800 |
| Cushion Type | MAC / MACD / MACJ Series: Variable cushion; Other Series: Bumper |
| Port Size | M5x0.8 | 1/8'' | 1/4'' |
Stroke of MA Series Pneumatic Cylinder:
Symbol of MA Series Pneumatic Cylinder:
Ordering Code of MA Series Pneumatic Cylinder:
Criteria for selection: Cylinder thrust:
Installation & Usage:
1. When load changes in the work, the cylinder with abundant output
capacity shall be ed.
2. Relative cylinder with high temperature resistance or corrosion
resistance shall be chosen under the condition of high temperature
or corrosion.
3. Necessary protection measure shall be taken in the environment
with higher humidity, much dust or water drops, oil dust and
welding dregs.
4. Dirty substances in the pipe must be eliminated before cylinder
is connected with pipeline to prevent the entrance of particles
into the cylinder.
5. The medium used by cylinder shall be filtered to 40μm or below.
6. Anti-freezing measure shall be adopted under low temperature
environment to prevent moisture freezing.
7. The cylinder shall be carried out test run without load before
application. Prior to run, buffer shall be turned to the minimum
and gradually released to avoid the damage on cylinder caused by
excessive impact.
8. The cylinder shall avoid the influence of side load in operation
to maintain the normal work of cylinder and extend the service
life.
9. If the cylinder is dismantled and stored for a long time, please
conduct anti-rust treatment to the surface. Anti-dust caps shall be
added in air inlet and outlet ports.
Focus on your demands, Offer you best solution:
√ Contact us if some points you have doubt
√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for
√ Contact us if you are doing designing
Welcome to your any question and inquiry!
