Chinese Compatible C5-2 Broadband Curved Array Transducer
1.Type:curved array
2.Frequency: 5-2 MHz
3.Compatible system:HD3,HD7
4.Application: abdominal, cardiac,OB/GYN
5.Warranty: 1 year
Other Philps Compatible probes we can offer:
| Brand | Model | Compatible System |
| C5-2 | HD3 |
| C5-2 | IU22, |
| C5-2 | HD5,HD7,HD11,HD11 XE,HD9 |
| C9-4EC | HD3 |
| L9-5 | HD3 |
| C8-4V | IU22 |
| C8-4V | HD11 |
| L12-5 | IU22 HD11 |
Warnings and cautions of ultrasonic probe
★The ultrasonic probe is a valuable device. It must be careful in
the process of use. Avoid dropping, impact, or abrasion to
transducers.
★When installing or removing the probe, first switch off the power
and then operate it carefully.
★Avoid rapid and extreme temperature changes, as well as lengthy
exposure to direct sunlight or a strong ultraviolet light source.
★Do not use sharp objects to penetrate the acoustic lens.Once the
acoustic lens is damaged, the coupling gel is easy to enter the
interior of the probe and damage the piezoelectric element.
★Do not soak transducer in any liquid above the recommended level as
stated in the user manual for your system, please operate according
to the manufacturer's instructions, otherwise it will lead to
circuit failure or even burn out.
★Do not disinfect at high temperature, because the probe is equipped
with piezoelectric ceramics, high temperature will weaken the
effect.
★Before use, carefully check whether the housing and cable are
damaged, so as to prevent the probe from high voltage injury.
★After the probe is used, the residual coupling gel on the probe
must be wiped clean to prevent rats or other animals from gnawing
the lens.
Storage for Transport of ultrasonic transducer
1. Make sure that the transducer is clean and disinfected before
placing it in the case to avoid contaminating the foam that lines
the carrying case.
2. Place the transducer in the case carefully to prevent kinking of
the cable.
3. Before closing the lid, make sure no part of the transducer is
protruding from the case.
4. Wrap the case in plastic material containing sealed-air pockets
(such as Bubble Wrap material), and pack the wrapped case in a
cardboard carton.
Daily and Long-Term Storage of ultrasound transducer
1. Always store transducers in the transducer holders on the side
of your system or on a securely mounted wall rack when you are not
using them.
2. Ensure the transducer holders are clean before storing
transducers
3. When storing transducers, use the cable-management clips, if
available, to secure the transducer cable
4. Avoid storing transducers in areas of temperature extremes or in
direct sunlight.
5. Store transducers separately from other instruments to avoid
inadvertent transducer damage.
6. Before storing transducers, make sure they are thoroughly dry.
