PMM Bulkhead Union Pneumatic Hose Fittings 1/8'' 1/4'' 3/8'' 1/2''
Bulkhead union push-in fittings. Classical bulkhead union with
push-in fittings on each side. Bulkhead connections are used when
there is a need to move pneumatic tube through some obstacle.
Simply drill a hole, push one part of bulkhead through it, and then
screw second part onto the other side. Available for all common
pneumatic tube diameters.
BRANDO’s push to connect fittings (or push-in fittings) are a quick
and convenient method of connecting components in a pneumatic
system. Designed for use with polyurethane, polyethylene, and nylon
tubing, our composite push-in fittings are available in a variety
of sizes to accommodate tubing ranging from 1/8 inch OD to 1/2 inch
OD. Numerous configurations are available to meet your connection
requirements.
Technical data of Pneumatic Hose Fittings:
Material | |
Threaded Connection | |
|
|
|
Working Pressure | |
Connecting Tube | |
|
Connecting Diameter Tube | 3mm, 4mm, 6mm, 8mm, 10mm, 12mm, 16mm (Outer Diameter) |
Medium | |
Working Temperature | |
Specifications of PMM Bulkhead Union Pneumatic Hose Fittings:
List of All Push To Connect Pneumatic Hose Fittings:
Choosing the Right Fittings for Your Pneumatic System:
Fittings help control the force and directional flow of compressed
gas or air used in pneumatic systems. One of the first
considerations in choosing a connector is the type of vessel that
you will be connecting to such as the flexibility of the hose or
tube, as well as the inner diameter (ID) and outer diameter (OD) of
the vessel to ensure an adequate seal and secure connection.
Fitting material choice for your pneumatic connector is also
important, including gas compatibility or resistance to heat or
corrosion.
Other considerations in choosing the right pneumatic system
connector include:
1. Type of connection and the function it performs
2. Operational pressure of the pneumatic system
3. Operating temperature range
4. P.S.I. requirements for your application
5. Amount of vibration produced by the pneumatic system
6. Thread type of the receiving fitting
Focus on your demands, Offer you best solution:
√ Contact us if some points you have doubt
√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for
√ Contact us if you are doing designing
Welcome to your any question and inquiry!
