Indoor 5G FTTx 0.3dB Fast Connector Fiber Optic Quick Connector
Single Mode
Indoor 5G FTTx 0.3dB LX58 SC APC Optical Fibre Field Assembly Fast
Connector Figure-8 Cable
SC/APC Fiber Optic Fast Connector is designed for FTTH is a new
generation of fiber connector used in assembly. It can provide Open
flow and Pre-cast type of products, whose optical and mechanical
specification meets the standard optical fiber connector.
It is designed for high quality and high efficiency for
installation the structure of crimping position is a unique design,
and need not gluing,
polishing neither any consumables. Adopting fiber pre-installed
structure, and convenient for field installation.
Features
1. SC / APC round screw type, total length 58mm
2. Apply to 2mm* 3mm fiber drop cable
3. Ceramic C-groove structure not plastic or metal, good sealing
performance, flame retardant
4. Insertion loss: the average ≤0.2dB, MAX≤0.4dB
5. Return loss: ≥50dB UPC, ≥65db APC
6. No need epoxy or polished, field-installable, factory embedded
fiber
Specification
Type | Parameters |
Insertion loss | ≤ 0.3dB (1310nm & 1550nm) |
Return loss | UPC ≤ -45dB, APC ≤ -65dB, |
Bare fiber strength | >5N |
Clad strength | >10N |
Tension | >50N |
Mechanical durability (500times) | IL ≤ 0.2dB & RL ≤ 5dB |
Operating Temperature | -5 ºC to +70 ºC |
Product Details:
Each one have a black switch to open and close the fiber on sit
construction, the boot is round which can screw on and off the open
the connectors.
All the connectors is made of high quality plastic, ensure good
performance stability and durability;
1pc/plastic bag, 100pcs/inner box, 10pcs inner box/carton box
How to use the fast connectors?
Process the fiber
1. Insert the drop cable into the stripper till 50-60mm out, and
strip the cable strength layer
2. Press the stripped cable into the clamp, there are 4points to
lock the fiber
3. Strip the cable coating layer by the insert the longitudinal
fiber stripper to strip the coating of the fiber. Or use Miller
stripper align of the fiber clamp.
4. Check the fiber by bending about 60°into direction if ok
5. Clean the fiber with alcohol cloth by 0°wipe and 90°again
6. Put the clamp into the length fixer till arrow up, and press to
the end
7. Lay flat on the fiber cleaver slot, align to the end, and then
cut the fiber
8. Finally the fiber length will be :19.4mm and 29.4±0.1mm,see
picture
Assembly
Check the black locker
Insert the fiber along with the V entrance till fiber bend, but not
higher than 1mm than V entrance
Keep housing, coating, and jig on the same level, take off the
switch.
Dis-assembly
Assemble the auxiliary jig,fit on switch to the right end
Unlock the fiber
Use the exclusive convex to open the cover, unlock the shell
Raise 15°to pull out the fiber
Other Similar Types:
Application
- Premise environments
- Connections at the desk for LAN environments
- Patch panels
- Direct equipment termination
- Fiber to the Subscriber / Home (FTTH) applications
- Repair/replacement requirements
- Equipment test leads
