Rt-1 is a single-module multifunctional mounting machine with a
capacity of 30000CPH～35000CPH. The components that can be mounted
include LED3014/3020/3528/5050, capacitors, resistors, IC and
special-shaped components.it applies to LED light and electric
board.
6.Company profile
Business terms:
| Accepted delivery terms | EXW, FOB, CIF, CFR |
| Accepted payment currency | USD,CNY |
| Accepted payment type | L/C, T/T |
| Nearest port | Shenzhen |
7.Our Our certificates and certifications
8. trade show
9. FAQ
contact
Name:Brynn
Email :Brynn@eton-mounter.com
WeChat:13802252825
Telephone:138 0225 2825
Industry related knowledge
Adaptability of SMT placement machine
Operation Process of Patch Machine
- Set the SET/STATUS/RECOVERY to E.STOP, production in this state,
observe the operation of the feeder, and replace and repair the
feeder. as needed Set the RECOVERY to AUTO. after the feeder is
found to be running properly
- Screen printing tin paste;
① Screen printing mold adjustment to ensure that the printed
solder paste is not defective;
② check PCB circuit board for defects, for deformation, no MARK
point or MARK point irregular circuit board, non-print tin paste
,(returned to warehouse);
③ Check the tin paste for welding, printing bad, or other bad
conditions, should clean the PCB board, with alcohol cleaning with
the air gun blow dry, and then baking re-printing paste.
- Patch machine Fida loading
① Return the TABLE used on the D board to both sides when feeding;
② Take off the feeder( feeder from the D shaft carefully and feed
as required.
③ Put the feeder flat on the D axis after good material, should
not warp;
④ feeder should be exposed on each feeding material, easy to
absorb suction mouth, and check D-DATA, no feeding errors;
⑤ To check feeder loose, abnormal, if bad, repair and maintenance
feeder; immediately
⑥ Should there be a TAPY Feeder alarm, must carefully check whether
there is a feeder cover with or without warp.
⑦ place the PCB board on the machine transport track in the
required direction, and require no more than 5 boards on PCB
machine track (including one of the X Y TABLE).
remove the pasted PCB board from the placement machine guide in
time and be sensed by the sensor.
QC employee shall correct all defects (e.g.: shift, dewelding,
component misleakage, etc.) on the pasted PCB board according to
the operation drawings, and put the corrected PCB board into the
plug-in box.
- Note: If the following anomalies exist, they should be immediately
reported to the technical staff for correction.
① The whole or partial displacement of the element;
② The missing parts, component skew etc.
③ Check that directional patch elements are in the right
direction, such as Triode, ICs, BGA, varactors and executives.
- Press the ENGERNCY key, then press the shutdown key on the
operating board;
- Press the key POWER OFF opening under the machine screen and then
put the main power switch on the OFF;.
- Turn off the air conditioning switch;
- OFF". the main power switch
