Kaeser Coupling Element E30 Omega Screw Air Compressor Coupling

The demand for better-performing machinery and equipment has been increasing in all areas of industry. Coupling as an important transmission component is no exception, in order to meet higher and more stringent quality requirements.

The reasons why the air compressor coupling does not turn are mainly as follows:

1. The errors of the levelness and coaxiality of the two axes are too large, which exceed the range of compensation of the coupling. As a result, the shaft teeth are not meshing correctly with the inner teeth, resulting in local contact and additional torque.And this additional torque can be broken down into axial forces.Acting on the inner gear ring, the force depends on the size of the deviation, and is proportional to the deviation, the greater the deviation, the greater the force, resulting in lifting accessories coupling inner gear ring axial displacement.If the displacement is too large to control, resulting in severe gear wear, or even broken teeth, internal and external teeth can not mesh, until can not drive.

2, Lifting accessories coupling insufficient oil or lack of oil.

Or grease use is improper, cause grease calcification, cause tooth face cannot lubricate, or lubricate badly to produce tooth face to wear seriously, this kind of circumstance should replace new grease only, inject qualified grease regularly, prevent oil leak, oil amount is sufficient, can avoid.

Characteristics of Omega Coupling

• Facility protection for twirl and twist, impact and abrasion
• Very simple replacement and maintenance without oil and grease
• Very simple replacement without the separation of motor or connector on the related line due to it’s simple structure
• Possible for the dissimilar connection and assembling with same hub
• Polyurethane based for having good water resistance, chemical resistance
• Highest flexible elasticity on run
• Less noise

Kaeser Coupling Element

​

Qingdao Futai, Air Compressor Filter Manufacturer in China.