5512 sintering pressurized furnace(it can reach the sinteing of
cemented carbide,ceramics and so on)
Profile of sinter-HIP furnace:
The ZZRDE company's pressurized sintering furnace series integrates
the functions of positive pressure dewaxing, vacuum dewaxing,
vacuum sintering, Tovac sintering, partial pressure sintering,
pressure sintering, atmosphere control, cooling and so on.
In order to meet different process requirements, Ar, H2, CH4, N2
and other gases or gas combinations can be imported under different
pressures and temperatures.
Horizontal design makes loading, unloading and maintenance
easier.The whole process is automatically controlled.
Technical parameter:
| Type | ZZRDE-SINTER-HIP FURNSCE5512 |
| Effective working zone(mm) | 500×500×1200 |
| Maximum loading weight | 1000KGS |
| Heating power | 410KVA |
| Max.design pressure | 10MPa |
| Max.working pressure | 9.50MPa |
| Max.design temperature | 1600℃ |
| Max.working temperature | 1550℃ |
| Temperature control mode | 3 zone temperature control |
| High temperature uniformity | ≤±5℃ |
Max.heating up speed (empty furnace) | 15℃/min(≤1000℃)；
10℃/min(1000-1520℃) |
| Ultimate vacuum degree | In cooling,empty and clean furnace chamber≤ 2Pa |
| Vacuum leakage rate | In cooling,empty and clean furnace chamber≤ 2Pa/h |
| Wax yield rate | ≥98﹪(paraffin) |
After sales:
1.Installation, Commissioning And Acceptance
We do installation, commissioning and acceptance in buyer's
plant.During the installation and commissioning period, the
commissioning personnel shall be provided free of charge by the
demander according to the staff standard.
The equipment shipped to the buyer, the seller received the buyer's
notification, both within a week to carry the equipment out of the
box together, then check the equipment and all components according
to the packing list . Including equipment accessories, spare parts
and special tools, attached manual and technical documents, etc. It
can be installed after the acceptance check of equipment.
After installation and debugging, the equipment shall be accepted
according to the technical accessories.
2.Training
When taking-over the Furnace to the customer, We will give a staff
training to customer. The operating personnel of the customer
should join to commission,test the furnace, when installing at
customer’s company.
This is practical operation training and practical maintenance
training,
and our technical personnel will telling the basic
principle,equipment maintenance knowledge,And the common fault
handling measures.We can training 2 ~ 3 workers. ( Training how to
maintenance and operating.)
3. Warranty period
The warranty period of the equipment is 12 months, which starts
from the date of installation and debugging of the supplier.
Equipment failure happens, after-sales service personnel shall give
solutions within 2 hours, after receiving the buyer's notification
. If it is need to go to the site for treatment , operators
dispatched by seller should arrive at the site within 48 hours
after go aboard. In case of emergency,operators should arrive at
the site within 48 hours after go aboard, and continue to make
repairs until the fault is removed and the equipment returns to
normal.
