there are many important characteristics of a rectifier which makes
them more suitable than a low-voltage generator for electroplating
processes:
Rectifier saves energy; it adopts a high-frequency switching power
supply transformer and as a result, the efficiency at which it
converts current improves.
It is lightweight and also very small; if you have a thyristor
rectifier, the size and weight will be 1/5-1/10. This weight and
size make it very easy for you to expand, plan, install, maintain
and move as the case may be.
Easy modulation; Rectifier output waveform can be modulated. Due to
high frequency, the cost of output waveform adjusting processing is
low and can be easily changed depending on what the users require.
As a result, there will be room to improve the efficiency on site
and also improve the quality of processing product.
Stability of output; the system has a high response speed, and as a
result, the rectifier can adapt strongly to load changes and
electricity network. This characteristic will ensure the accuracy
of more than 1%. Also, the switching power supply works very
efficiently to enable high precision control which will, in turn,
improve the products quality.
90V 100A IGBT galvanization rectifier Optional Properties
Profibus DP
- 12mbit Profibus DP concordance,opportunuty to connect single or
in groups ProfiNet- 100 Mbit
ProfiNet
Concordance,opportunuty to connect single or in groups
Modbus-
Modbus communications over Ethernet or RS485
Ethernet Serial Communication
-Communication over RS 232 or RS485 on Mak Plus or a different
protocol 100Mbit wired, 54 Mbit wireless
Analog Reference
- 0-10 V or 4-20 mA DC signal and the Current - Voltage control
PC Control
-Serial and Wireless Communication over RS 232/485 on MRS control
software
PLC Control-
Ability to control motor system with two relay contact
