Astra Tech OsseoSpeed® Implant Internal Titanium Premill Blank 10mm
Engaging
Yellow(NP 3.0mm) / AQUA(RP 3.5/4.0mm) / LILAC(WP 4.5/5.0mm)
Material:
Ti 6AI-4V ELI (Supply from Germany)
Feature:
* Simply efficiency
* Precision machined up to ± 5µm
* Benefit from a faster and controlled turnaround time
* Different diameter available of 10mm, 14mm
Pre-milled Abutment Blanks, you can now produce titanium customised
abutments with your milling equipment.
Boost your efficiency by using your milling machines and benefit
from all major implant connections.
Approved by CE, ISO 9001, ISO 13485
* We also can provide another 3 type of premill as above picture
shown. Welcome to further inquire. Thanks.
Points of Astra OsseoSpeed™ Dental Implant:
Fig.5
Profile implants are produced with the same grade 4 titanium and
surface texture (Fig.4) as standard OsseoSpeed™ implants. The
coronal portion of the Profile implant is cut at a 30 ° angle (Fig.5) half way through the diameter of the implant. This
feature may allow placement of the implant in to a sloping bony
crest without bone grafting or a portion of the implant above or
below the bone at the time of implant placement. The
implant/abutment interface connection is constructed as a internal,
double hex conical connection (Fig.2), allowing 6 different
positions for final abutments and machined to the same dimensions
regardless of the implant diameter..
Fig.6
TX S Profile implants (Fig.6) are machined with a parallel geometry and a
tapered apex. Two outside thread patterns are machined on to the
implant body consisting of micro threads at the coronal portion and
a regular thread pattern on the main portion of the implant. One
implant diameter of 5.0mm, available in lengths of 9, 11, 13, 15
and 17mm comprises the TX S Profile product group.
Fig.7
TX Profile implants (Fig.7) are machined with a parallel main body geometry
and a conical crestal portion with a tapered apex. Two outside
thread patterns are machined on to the implant body consisting of
micro threads at the coronal portion and a regular thread pattern
on the main portion of the implant. Two implant diameters of 4.5mm
and 5.0mm, available in lengths of 9, 11, 13, 15 and 17mm comprises
the TX Profile product group.
