220V Four Indicator Lights Disinfection Lamp PCBA Circuit Board
Germicidal Lamp
Specification
| IInput power | AC 220V 40W about 0.181A |
| Output parameter | germicidal lamp 36W |
| Drive type | Relay |
| Measurement accuracy requirement | time accuracy 5% |
| Man-machine interface display | four indicator lights, one red and three green |
| Man-machine interface input | one touch spring, control switch and file selection |
| Input and output interface type | VH3.96-2PIN-DIP |
| Application | kindergartens, offices, parks,etc |
Description
It has single touch button: TP, four indicators: D1 (switch
indicator), D2 (15min working indicator), D3 (30min working
indicator), D4 (1h working indicator)
At the initial power-on, only the D1 indicator is on, but the
germicidal lamp and other indicators are not on.
Operation
In non-working state, press the TP key to select the working time
of the germicidal lamp. Every short press (key duration <3S),
the TP key changes in sequence along [15min-30min-60min], and the
cycle time is within 3S.
Re-selection, at the same time, the D1 indicator is off, the
indicator corresponding to the selected working time lights up;
after 3S waiting, the indicator of D1 and the corresponding working
time flashes, and the buzzer sounds 10 times once per second, and
the sterilization lamp starts after 10S Lights up, at the same time
D1 and the corresponding work indicator light are always on.
Application
Disinfection and sterilization in kindergartens, offices, parks,
family rooms, and balconies and hotels.
Quality inspection
1. Appearance inspection: Check the installation and welding of the
original
2. Component push pull test: use push pull meter to check the
welding and fastness of components
3. Rigorous testing: Each product must be tested before it can be
shipped.
Package
1. Anti-static bubble film shall be used for packaging and packing
after piecing together
2. Matters needing attention when packing
1) Considering the force comprehensively, the direction set up
after PCBA packing should be the same as that of corrugated carton
2) Avoid the collision between PCBas during packaging; Appropriate
placement and bubble film thickness should be selected
