1000Mm Glass Turning Table For Rotating Glass When Coating Silicone
Sealants
Rotating Table Machine
Main feature:
• Easy operating, simple and flexible
• It is used for fixing and rotating glass when manual coating the
outside of IG glass
• The middle sucker is suitable for small pieces of
glass,however,extra support frame is for large pieces of glass
- Working environment Parameter Unit Remarks
- Working environment temperature 15-40℃
- Carry/deposit temperature -20-55℃
- Carry/deposit humidity 30-90%
- Basic characteristic
- Input voltage AC400V±10%,60HZ
- Input power 120 W
- Rotated speed 6.5 r/min
- Air consumption 0.5-0.8 Mpa
- Max glass size 2000*1500 mm
- Min glass size 200*200 mm
- Dimensions 600*450*950 mm
| Power supply | 380V 50Hz |
| Total power | 0.37kw |
| Operating dimension | 1500*1500mm / |
| Dimension | 600*550*985mm
|
Attention :
1. When tune up to prop up the tight in a bolt for and glass
contact even empress, must will prop up a top, prop up otherwise
the pole turns to move, prop up, the round escapes from the glass,
will produce the glass move the phenomenon.
2. Big sucker in usage, doing not want will enter the barometric
dint adjusts of over high, otherwise the vacuum a glass for too
bigger, being usage thickness is thinner, easy is ground the glass.
Maintenance :
1. New machine through revolving of a period of time after, should
open the plank, check whether each tight firmware loosen or not
moves, laying equal stress on the new tight.
2. Make to complete each time, want to clean dust and gum
clearances of the machine, combine to cover the turn over dish,
keep dust from falling into sucker.
3. Prop up set and prop up the pole should periodically draw the
lubrication grease, resisting rust.
4. The periodical check electricity connects whether line loose or
not moves, and connect the dependable of the ground.
More introduce:
1,Usage
The Rotated sealant-spreading table is last preface of creation
insulation glass or act wall glass. It is a rotated table for draw
double group gum. It can proceed 90°Integral times rotated,also can
proceed face or contrary rotated. Revolve and vacuum sucker have
auto control equipment, it can combine glass size freedom choice
sucker and stretch arm control. Stretch arm of Special creation can
guarantee the top flat surface on a flat surface. This rotated
sealant-spreading table is rotated steady; Break down low, prop up
the stability. It is an ideal equipment to create insulating glass.
2,Main technical parameters
3,Main construction
This machine include Adjust flat bottom,Prop up,Revolve to prop up
the device,Spread to move the device, spirit carries control
system, electric appliances control system and plank.
3.1 Revolve prop up the device
Revolve prop up the device include the prop up,prop up the
pole,prop up set,big sucker, small sucker.
3.2 Spread to move the device
This device consisted the Spread to move the deceleration
electrical engineering,decelerate machine and chain round.
3.3 Spirit carries control system
This system included the Spirit source processor, electromagnetism
valve, singled direction valve and vacuum occurrence machine, pass
the system control the matches of the size sucker.
